Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- Signage Setup
- Power On Status
- Wake On LAN
- LAN Daisy Chain
- Power Off Management
- Rotation
- Beacon
- Baudrate (9600/115200)
- Power On Delay (0 ~ 250)
- Check Screen
- Digital Audio Input
- Speaker
- USB Auto Playback
- Interface Selection
- OPS Power Control
- Multi Display Mode
- Power Indicator
- Sync Mode
- Intelligent Auto
- Studio Mode
- HDMI IT Contents
- White Balance
- Application
- Web Browser
- Status Message
- SIMPLINK Setup
- Local Dimming
- Holiday Schedule
- Easy Brightness Control
- Analog Signage BLU Setting
- Crestron
- Enterprise Settings
- No Signal Image
- Signage 365 Care
- Quiet mode (Fan OFF)
- Factory Reset
- Guide to Using Content Rotation
- USB Cloning
- Password Change
- Fail Over
- ISM Method
- Server
- Lock Mode
- Signage Setup
ENGLISH
20
TROUBLESHOOTING
No image is displayed.
Problem Action
Is the product power cord connected? • Check if the power cord is correctly plugged into the power outlet.
Does the “Invalid Format” message
appear?
• The signal from the PC (Graphics card) is out of the vertical or
horizontal frequency range of the product. Adjust the frequency range
by referring to the Specifications in this manual.
Does the “No Signal” message appear? • The signal cable between PC and product is not connected. Check the
signal cable.
• Press the INPUT menu in the remote control to check the input signal.
The “Unknown Product” message appears when the product is connected.
Problem Action
Did you install the driver? • Check if the Plug and Play function is supported by referring to the
graphics card user manual.
The screen image looks abnormal.
Problem Action
Is the screen position wrong? • Check if the graphics card resolution and frequency are supported by
the product. If the frequency is out of range, set to the recommended
resolution in the [Control Panel] → [Display] → [Setting] menu. (The
settings may differ depending on your operating system.)
The screen is displayed abnormally. • The proper input signal is not connected to the signal port. Connect the
signal cable that matches with the source input signal.