Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- Signage Setup
- Power On Status
- Wake On LAN
- LAN Daisy Chain
- Power Off Management
- Rotation
- Beacon
- Baudrate (9600/115200)
- Power On Delay (0 ~ 250)
- Check Screen
- Digital Audio Input
- Speaker
- USB Auto Playback
- Interface Selection
- OPS Power Control
- Multi Display Mode
- Power Indicator
- Sync Mode
- Intelligent Auto
- Studio Mode
- HDMI IT Contents
- White Balance
- Application
- Web Browser
- Status Message
- SIMPLINK Setup
- Local Dimming
- Holiday Schedule
- Easy Brightness Control
- Analog Signage BLU Setting
- Crestron
- Enterprise Settings
- No Signal Image
- Signage 365 Care
- Quiet mode (Fan OFF)
- Factory Reset
- Guide to Using Content Rotation
- USB Cloning
- Password Change
- Fail Over
- ISM Method
- Server
- Lock Mode
- Signage Setup
ENGLISH_index
38
TO CONTROL MULTIPLE PRODUCTS
• Only applies to certain models.
Use this method to connect several products to a single PC. You can control several products at a time by connecting
them to a single PC.
In the Option menu, the Set ID must be between 1 and 1000 without being duplicated.
Connecting the Cable
• The image may be different according to the model.
Connect the RS-232C cable as shown in the picture.
The RS-232C protocol is used for communication between the PC and product. You can turn the product on or off,
select an input source or adjust the OSD menu from your PC.
Monitor 1 Monitor 2 Monitor 3Monitor 4
PC
RS-232C
IN
RS-232C
OUT
RS-232C
IN
RS-232C
OUT
RS-232C
IN
RS-232C
OUT
RS-232C
IN
RS-232C
OUT
RS-232C
Gender
4P Cable
(not included)
RS-232C Cable
(not included)
Monitor 1 Monitor 2 Monitor 3 Monitor 4
PC
RS-232C Cable (not included)