Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- Signage Setup
- Power On Status
- Wake On LAN
- LAN Daisy Chain
- Power Off Management
- Rotation
- Beacon
- Baudrate (9600/115200)
- Power On Delay (0 ~ 250)
- Check Screen
- Digital Audio Input
- Speaker
- USB Auto Playback
- Interface Selection
- OPS Power Control
- Multi Display Mode
- Power Indicator
- Sync Mode
- Intelligent Auto
- Studio Mode
- HDMI IT Contents
- White Balance
- Application
- Web Browser
- Status Message
- SIMPLINK Setup
- Local Dimming
- Holiday Schedule
- Easy Brightness Control
- Analog Signage BLU Setting
- Crestron
- Enterprise Settings
- No Signal Image
- Signage 365 Care
- Quiet mode (Fan OFF)
- Factory Reset
- Guide to Using Content Rotation
- USB Cloning
- Password Change
- Fail Over
- ISM Method
- Server
- Lock Mode
- Signage Setup
ENGLISH_index
50
23. [No Signal Power Off] (15Min) (Command: f g)
Sets the monitor to enter Automatic Standby mode if there is no signal
for 15 minutes.
Transmission
(f)(g)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(g)( )(Set ID)( )(OK/NG)(Data)(x)
24. [Auto Power Off] (4 Hours) (Command: m n)
Sets the monitor to enter Auto Power Off after 4 hours.
Transmission
(m)(n)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: 4 hours
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(Data)(x)
25. [Language] (Command: f i)
Sets the OSD language.
Transmission
(f)(i)( )(Set ID)( )(Data)(Cr)
Data 00: Czech
01: Danish
02: German
03: English
04: Spanish (Europe)
05: Greek
06: French
07: Italian
08: Dutch
09: Norwegian
0A: Portuguese
0B: Portuguese (Brazil)
0C: Russian
0D: Finnish
0E: Swedish
0F: Korean
10: Chinese (Mandarin)
11: Japanese
12: Chinese (Cantonese)
13: Arabic
Acknowledgement
(i)( )(Set ID)( )(OK/NG)(Data)(x)
26. [Reset] (Command: f k)
Performs the reset function.
Screen Reset can only be performed in RGB input mode.
Transmission
(f)(k)( )(Set ID)( )(Data)(Cr)
Data 00: Picture Reset
01: Screen reset
02: Initial Settings
Acknowledgement
(k)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
27. [Current temperature] (Command: d n)
Checks the inside temperature.
Transmission
(d)(n)( )(Set ID)( )(Data)(Cr)
Data FF: Check the status
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(Data)(x)
* Temperature is displayed as a hexadecimal value.
28. [Key] (Command: m c)
Sends a key code for the IR remote control.
Transmission
(m)(c)( )(Set ID)( )(Data)(Cr)
Data IR_KEY_CODE
Acknowledgement
(c)( )(Set ID)( )(OK/NG)(Data)(x)
* For key codes, see IR Codes.
* Some key codes are not supported depending on the model.