Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- Signage Setup
- Power On Status
- Wake On LAN
- LAN Daisy Chain
- Power Off Management
- Rotation
- Beacon
- Baudrate (9600/115200)
- Power On Delay (0 ~ 250)
- Check Screen
- Digital Audio Input
- Speaker
- USB Auto Playback
- Interface Selection
- OPS Power Control
- Multi Display Mode
- Power Indicator
- Sync Mode
- Intelligent Auto
- Studio Mode
- HDMI IT Contents
- White Balance
- Application
- Web Browser
- Status Message
- SIMPLINK Setup
- Local Dimming
- Holiday Schedule
- Easy Brightness Control
- Analog Signage BLU Setting
- Crestron
- Enterprise Settings
- No Signal Image
- Signage 365 Care
- Quiet mode (Fan OFF)
- Factory Reset
- Guide to Using Content Rotation
- USB Cloning
- Password Change
- Fail Over
- ISM Method
- Server
- Lock Mode
- Signage Setup
ENGLISH_index
53
43. [Natural Mode] (in Tile mode) (Command: d j)
When displaying the image naturally, the part of the image that would
normally be displayed in the gap between the monitors is omitted.
Transmission
(d)(j)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(j)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
44. [DPM Select] (Command: f j)
To set the DPM (Display Power Management) function.
Transmission
(f)(j)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: 5 seconds
02: 10 seconds
03: 15 seconds
04: 1 minutes
05: 3 minutes
06: 5 minutes
07: 10 minutes
Acknowledgement
(j)( )(Set ID)( )(OK/NG)(Data)(x)
45. [Remote Control] / [Local Key Lock] (Command: k m)
Adjusts the remote control/local key (front) lock.
Transmission
(k)(m)( )(Set ID)( )(Data)(Cr)
Data 00: Off (Lock Off)
01: On (Lock On)
* When the monitor is turned off, the power key works even in On (01)
mode.
Acknowledgement
(m)( )(Set ID)( )(OK/NG)(Data)(x)
46. [Power On Delay] (Command: f h)
Sets the schedule delay when the power turns on. (unit: seconds).
Transmission
(f)(h)( )(Set ID)( )(Data)(Cr)
Data 00~FA: min. 0 to maximum 250 (seconds)
* The maximum value may differ depending on the model.
Acknowledgement
(h)( )(Set ID)( )(OK/NG)(Data)(x)
47. [Fail Over Select] (Command: m i)
Selects an input mode for auto switch.
Transmission
(m)(i)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: Auto
02: Manual
Acknowledgement
(i)( )(Set ID)( )(OK/NG)(Data)(x)