User Guide

ENGLISH_index
53
43. [Natural Mode] (in Tile mode) (Command: d j)
When displaying the image naturally, the part of the image that would
normally be displayed in the gap between the monitors is omitted.
Transmission
(d)(j)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(j)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
44. [DPM (Standby Mode)] (Command: f j)
To set the DPM (Display Power Management) function.
Transmission
(f)(j)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: 5 seconds
02: 10 seconds
03: 15 seconds
04: 1 minutes
05: 3 minutes
06: 5 minutes
07: 10 minutes
Acknowledgement
(j)( )(Set ID)( )(OK/NG)(Data)(x)
45. [Remote Control] / [Local Key Lock] (Command: k m)
Adjusts the remote control/local key (front) lock.
Transmission
(k)(m)( )(Set ID)( )(Data)(Cr)
Data 00: Off (Lock Off)
01: On (Lock On)
* When the monitor is turned off, the power key works even in On (01)
mode.
Acknowledgement
(m)( )(Set ID)( )(OK/NG)(Data)(x)
46. [Power On Delay] (Command: f h)
Sets the schedule delay when the power turns on. (unit: seconds).
Transmission
(f)(h)( )(Set ID)( )(Data)(Cr)
Data 00~FA: min. 0 to maximum 250 (seconds)
* The maximum value may differ depending on the model.
Acknowledgement
(h)( )(Set ID)( )(OK/NG)(Data)(x)
47. [Fail Over Select] (Command: m i)
Selects an input mode for auto switch.
Transmission
(m)(i)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: Auto
02: Manual
Acknowledgement
(i)( )(Set ID)( )(OK/NG)(Data)(x)