User Guide

ENGLISH_index
55
Data 10 (Check Screen)
Data1 00: Check Screen result NG
07: Check Screen result OK
* Sets to NG when Check Screen is set to Off or not supported.
Data 13(For checking Door State)
Data1 Number of the door to check
Data2 00: Closed
01: Opened
Data 15 (when checking the current electric current value)
Data1 Current electric current value in mA
Data 16(For checking Humidity)
Data1 Display the current humidity (%RH) in the Hex value
Data 17(For checking Illuminance)
Data1 Display the current illumination (Lux) in the Hex value
Data 18(For checking the Rotation (Gyro) State)
Data1 00: 0 degrees
01: 90 degrees
02: 180 degrees
03: 270 degrees
Data 09 (In the case of Fan Speed)
Acknowledgement
(v)( )(Set ID)( )(OK/NG)(Data)(Data1)(Data2)(x)
Data1 00-ff: The upper 1-byte of the fan speed
Data2 00-ff: The lower 1-byte of the fan speed
Fan speed: 0 to 2008 in hexadecimal and 0 to 8200 in decimal
* This may not be supported on some models.
52. [Check Screen] (Command: t z)
Sets Check Screen.
Transmission
(t)(z)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(z)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
53. [Speaker] (Command: d v)
Sets the speaker function.
Transmission
(d)(v)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(v)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
54. [Daylight Saving Time] (Command: s d)
To set the Daylight Saving Time function.
Transmission
(s)(d)( )(Set ID)( )(Data1)( )(Data2)( )(Data3)( )(Data4)
( )(Data5)(Cr)
Data 00: Off (Data2~5: FFH)
01: Start Time
02: End Time
Data2 01~0C: January to December
Data3 01~06: 1~6th week
* The maximum number of [Data3] differs depending on Date.
Data4 00~06 ( Sun. ~ Sat. )
Data5 00~17: 00~23 hours
* To read the Start Time/End Time, enter FFH for [Data2]~[Data5].
(Example 1: sd 01 01 ff ff ff ff - To check the Start Time)
(Example 2: sd 01 02 ff ff ff ff - To check the End Time)
* This function is supported only when 1 (Year/Month/ Day) and 2 (Hour/
Minute/Second) are set.
Acknowledgement
(d)( )(Set ID)( )(OK/NG)(Data1)(Data2)(Data3)(Data4)
(Data5)(x)
* It may not be supported depending on the model.