Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- Signage Setup
- Power On Status
- Wake On LAN
- LAN Daisy Chain
- Power Off Management
- Rotation
- Beacon
- Baudrate (9600/115200)
- Power On Delay (0 ~ 250)
- Check Screen
- Digital Audio Input
- Speaker
- USB Auto Playback
- Interface Selection
- OPS Power Control
- Multi Display Mode
- Power Indicator
- Sync Mode
- Intelligent Auto
- Studio Mode
- HDMI IT Contents
- White Balance
- Application
- Web Browser
- Status Message
- SIMPLINK Setup
- Local Dimming
- Holiday Schedule
- Easy Brightness Control
- Analog Signage BLU Setting
- Crestron
- Enterprise Settings
- No Signal Image
- Signage 365 Care
- Quiet mode (Fan OFF)
- Factory Reset
- Guide to Using Content Rotation
- USB Cloning
- Password Change
- Fail Over
- ISM Method
- Server
- Lock Mode
- Signage Setup
Server
Set Automatically
• The monitor settings will be set automatically so that the SuperSign server can search it.
Server IP Type
• Select the IPv4 or the IPv6 type.
Server IP
• This is a menu where you can set an IP address for the SuperSign server.
Server Status
• Server Status displays the status of the connection between your monitor and the SuperSign server.
• Not Connected - indicates that your monitor is not connected to the SuperSign server.
• Waiting for Approval - indicates that your monitor is connected to the SuperSign server but not yet approved.
• Rejected - indicates that your monitor is connected to the SuperSign server but has been rejected.
• Connected - indicates that your monitor is connected to the SuperSign server and has been approved.
Port Number
• Sets the SuperSign server's port. (Supported on SuperSign Premium 1.0 or later)
Secured Connection
• You can choose whether to use security protocols when connecting to the SuperSign server. (Supported on
SuperSign Premium 1.0 or later)
Control Server IP Type
• Select the IPv4 or the IPv6 type.
Control Server IP
• This menu is to set the IP of the SuperSign Control Server.
Control Server Port
• This menu is to set the port of the SuperSign Control Server.
Control Server Status
• This displays the status of connection with the SuperSign Control Server.
• Not Connected: When not connected to the SuperSign Control Server
• Waiting for Approval: When connected to the SuperSign Control Server but not approved
• Connected: When connected to the SuperSign Control Server and approved
ENGLISH
27