Owner’s Manual
Table Of Contents
- OWNER’S MANUAL
- USER GUIDE
- INSTALLATION MANUAL
- ACCESSING INSTALLATION MENU
- INSTALLATION MENU
- Signage Setup
- Power On Status
- Wake On LAN
- LAN Daisy Chain
- Power Off Management
- Rotation
- Beacon
- Baudrate (9600/115200)
- Power On Delay (0 ~ 250)
- Check Screen
- Digital Audio Input
- Speaker
- USB Auto Playback
- Interface Selection
- OPS Power Control
- Multi Display Mode
- Power Indicator
- Sync Mode
- Intelligent Auto
- Studio Mode
- HDMI IT Contents
- White Balance
- Application
- Web Browser
- Status Message
- SIMPLINK Setup
- Local Dimming
- Holiday Schedule
- Easy Brightness Control
- Analog Signage BLU Setting
- Crestron
- Enterprise Settings
- No Signal Image
- Signage 365 Care
- Quiet mode (Fan OFF)
- Factory Reset
- Guide to Using Content Rotation
- USB Cloning
- Password Change
- Fail Over
- ISM Method
- Server
- Lock Mode
- Signage Setup
ENGLISH_index
58
64. [Intelligent Auto] (Command: t i)
Selects the desired Intelligent Auto option.
Transmission
(t)(i)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(i)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
65. [OSD Portrait Mode] (Command: t h)
Selects the desired Portrait mode option.
Transmission
(t)(h)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: 90 degrees
02: 270 degrees
03: 180 degrees
Acknowledgement
(h)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
66. [Reset to Initial Settings] (Command: t n)
Enables/disables the Reset to Initial settings.
Transmission
(t)(n)( )(Set ID)( )(Data)(Cr)
Data 00: Disables the settings
01: Enables the settings
Acknowledgement
(n)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
67. [Time Sync] (Command: s n, 16)
Configures the Time Sync.
Transmission
(s)(n)( )(Set ID)( )(1)(6)( )(Data)(Cr)
Data 00: Off
01: On
* This feature works in the Master mode.
* This feature does not work if the current time is not set.
Acknowledgement
(n)( )(Set ID)( )(OK/NG)( )(1)(6)( )(Data)(x)
* It may not be supported depending on the model.
68. [Contents Sync] (Command: t g)
Configures the Contents Sync.
Transmission
(t)(g)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(g)( )(Set ID)( )(OK/NG)(Data)(x)
* It may not be supported depending on the model.
69. [Pivot Mode] (Command: t a)
Sets Pivot Mode to on/off.
Transmission
(t)(a)( )(Set ID)( )(Data)(Cr)
Data 00: Off
01: On
Acknowledgement
(a)( )(Set ID)( )(OK/NG)(Data)(x)
* This feature may not be supported in certain models.