Owner’s Manual

ENGLISH
64
21. Set [Default] (Command: f k)
Executes Reset.
Initialize Screen can only be executed in RGB input mode.
Transmission
(f)(k)( )([Set ID])( )(Data)(Cr)
Data 00: Picture Reset
01: Initialize Screen
02: Reset to Initial Settings
Acknowledgment
(k)( )([Set ID])( )(OK/NG)(Data)(x)
* This feature may not be supported on some models.
22. Current Temperature (Command: d n)
Checks the current temperature of the product.
Transmission
(d)(n)( )([Set ID])( )(Data)(Cr)
Data FF: Check status
Acknowledgment
(n)( )([Set ID])( )(OK/NG)(Data)(x)
* The temperature is displayed in hexadecimal.
23. [Key] (Command: m c)
Sends a key code for the IR remote control.
Transmission
(m)(c)( )([Set ID])( )(Data)(Cr)
Data IR_KEY_CODE
Acknowledgment
(c)( )([Set ID])( )(OK/NG)(Data)(x)
For key codes, see IR Codes.
* Some key codes may not be supported on some models.
24. Time Elapsed (Command: d l)
Displays the time that has elapsed after your monitor has
turned on.
Transmission
(d)(l)( )([Set ID])( )(Data)(Cr)
Data FF: Reads status
Acknowledgment
(l)( )([Set ID])( )(OK/NG)(Data)(x)
* The data received is displayed in hexadecimal.
25. Product Serial Number (Command: f y)
Checks the serial number of the product.
Transmission
(f)(y)( )([Set ID])( )(Data)(Cr)
Data FF: Checks product serial number
Acknowledgment
(y)( )([Set ID])( )(OK/NG)(Data)(x)
Data is in ASCII format.
26. Software Version (Command: f z)
Checks the software version of the product.
Transmission
(f)(z)( )([Set ID])( )(Data)(Cr)
Data FF: Checks software version
Acknowledgment
(z)( )([Set ID])( )(OK/NG)(Data)(x)