Installation Manual

5
ENG
ENGLISH
Auto Power O

You can choose whether to use the 4 Hours Off feature.

You can set this option to 4 Hours or Off.

If you set this option to 4 Hours, the product turns off when you have not pressed any buttons on the remote
control for 4 hours.

If you set this option to Off, the 4 Hours Off feature becomes disabled.

Set this option to Off when you use the product for a long period of time.
DPM

You can configure the DPM (Display Power Management) function.

Off: you can set this option to Off, 5 sec./10 sec./15 sec./1 min./3 min./5 min./10 min.

If this option is not set to Off, the monitor set enters the DPM mode when there is no input signal.

If you set this option to Off, the DPM function is disabled.

In the following cases, you can set DPM to Off or 10 min only. If DPM was set to 5 sec, 10 sec, 15 sec, 1 min, or 5
min, it will be changed to 10 min.
- When USB Auto Playback is set to Photo or Movie
- When Fail Over is set to Auto or Manual
Baud rate (9600/115200)

You can change the RS-232 communication speed for controlling your monitor.

You can choose 9600 or 115200.

If you set this option to 9600, the RS-232 communication speed is set at 9600 bps.

If you set this option to 115200, the RS-232 communication speed is set at 115200 bps.
OSD Portrait Mode (O, On)

Rotates the OSD counterclockwise.

You can set this option to On or Off.

If you set this option to Off, the function is deactivated.

If turned On, the OSD will rotate 90 degrees counterclockwise. In this case, you can not use a mouse.
Check Screen

The Check Screen feature judges whether there are abnormalities at the edges of the screen. R, G, and B OSDs
are formed on the screen at one second intervals and an RGB Sensor tests the areas.

If set to On, the Check Screen feature is enabled.

If set to Off, the Check Screen feature is disabled.

When the Portrait mode is On, the Check Screen feature is Off and deactivated.