Owner's Manual

20 Multi Type Air Conditioner
High
Speed
R
Power
button
Operating Instructions
The operation will be started operation if the
power button is pressed without remote
controller.
If you want to stop operation, re-press the
button.
Heat pump Model
Cooling Model
Room Temp. ≥ 24°C 21°C ≤ Room Temp. < 24°C Room Temp. < 21°C
Operating mode Cooling Cooling Healthy Dehumidification Heating
Indoor FAN Speed High High High High
Setting Temperature 22°C 22°C Air Intake Temperature 24°C
In case the power comes on again after a power failure, the unit operates automatically to the previous operating
conditions.
So there is no need of activating this function by pressing any key or button.
In the initial mode, the fan operates at a low speed and the compressor starts about 3 minutes later.
As the compressor starts, the fan speed also resumes its previous setting mode.
WHEN THE FRONT GRILLE IS OPENED:
o Once the front grille is opened for cleaning of the air filters or other reasons, the unit automatically stops
operation for safety: In some 60 Hz models (for cooling only), all memorized functions such as operation mode,
room temperature setting, operation start & stop by timer setting, etc. shall be erased.
o To restart the unit, close the front grille and press the Start/Stop button on the remote controller.
If necessary, please reset the reservation functions like operation start & stop and room temperature setting.
Helpful information
Fan speed and cooling capacity.
The cooling capacity indicated in the specification is
the value when the fan speed is set to high, and the
capacity will be lower at low or medium fan speed.
High fan speed is recommended when you wish to
cool the room quickly.
Forced Operation
Auto restart
: In case of absence for a long time while power failure, turn off main power to avoid undesired Auto
restart.
WARNING