Installation Manual

Installation Manual 27
How to Set E.S.P?
ENGLISH
<Type 2>
1. Enter the installer mode on the remote control and select Auto ESP.
2. Select the setting category, and press [
∧
(up)] button for 3
seconds to enter the password
input screen for the installer setting.
3. Input the password and press [OK] button to move to the installer setting list. And Selet Auto
ESP
4. After selecting “Manual”, set the Voltage(190V - 270V) as shown in the screen.
5. It takes about 3-8 minutes to set, and you can see the setting result as Pass or Fail.
NOTE
If Auto ESP is incorrectly set, the air conditioner may malfunction.
This function must be set by an installation specialist with an installation license.
This function is an additional function of the product and may not work in some models.
Wired remote control does not work while 'Auto ESP' is set.