Owner’s Manual

4 IMPORTANT SAFETY INSTRUCTIONS
Installation
Contact the dealer, seller, a qualified electrician, or an authorized service center when installing or
relocating the product.
Do not install, remove or re-install the unit by yourself(customer).
For electrical work, contact the dealer, seller, a qualified electrician, or an Authorized service center.
Use only those parts listed in the service parts list. Never attempt to modify the equipment.
When installing the unit, use the installation kit provided with the product.
Do not install the unit in potentially explosive atmospheres.
Do not install the product in a place where flammable liquids or gases such as gasoline, propane or paint
thinner are stored.
Be sure the installation area does not deteriorate over time.
Do not install the product on a defective installation stand.
Install the panel and the cover of the control box safely.
Install a dedicated electrical outlet and circuit breaker before using the product.
Use a standard circuit breaker and fuse that conform to the rating of the product.
Always ground the product.
Tightly secure the indoor/outdoor wiring connections. Route the cable properly so nothing is exerting
force on the cable that could disconnect it from the connection terminals. Improper or loose connections
can generate heat or cause a fire.
Do not turn on the breaker or power while the front panel, cabinet, top cover or control box cover are
removed or opened.
Use non-flammable gas (nitrogen) to check for leaks and to purge air; using compressed air or
flammable gas may cause a fire or explosion.
Operation
Do not modify or extend the power cable. Scratches or peeling insulation on the power cables may result
in fire or electric shock. Replace damaged insulation.
Make sure that the power cable is not dirty, loose, or broken.
Do not place a heater or other heating appliances near the power cable.
Make sure that the power cable cannot be pulled out or damaged during operation.
Never touch, operate, or repair the product with wet hands.
Do not insert hands or other objects through the air inlet or outlet while the product is operating.
Make sure that children do not climb on or hit the outdoor unit.
Do not touch the refrigerant pipe, water pipe or any internal parts while the unit is operating or
immediately after operation.
Do not open the inlet grille of the product during operation.
Do not leave flammable substances such as gasoline, benzene, or thinner near the product.
Do not use flammable substances such as hair spray, lacquer, or paint near the product.
Do not use the product for an extended period of time in a small area without proper ventilation.
Be sure to ventilate sufficiently when the product and a heating appliance such as a heater are used
simultaneously.
Do not block the inlet or outlet of airflow.
Cut off the power supply if there is any noise, smell, or smoke coming from the product.
Be cautious that water could not enter the product.
Contact an authorized service center if the product is submerged in water.