Owner's Manual

Open
the front
panel upward
High
Speed
Power
button
Heater
Operation
1.
Pressing
the Heater button
during Heating
Operation
enables the
built-in heater to
operate
a
strong heating
function.
2. If Heater
Operation
is
on,
Ho
(Heater On)
is shown at the
Operation
indication
lamps
and there is no
change
at the remote controller.
The heater consumes much
electricity,
so Heater
Operation may
cost more.
If the
Start/Stop
button is
pressed
during
Heater
Operation,
the indoor fan is
operated
to cool
the heater for about 15 seconds and the unit
stops
operating.
NOTICE
Operating
Instructions
20 Room
Air
Conditioner
Operation procedures
when the remote control can't be used.
The
operation
will be started if the
power
button is
pressed.
If
you
want to
stop operation, re-press
the button.
Heat
pump
Model
Cooling
Model
Room
Temp.
≥ 24°C2 1 °C ≤ Room
Temp.
< 24°CR oo m T e m
p
. < 2 1 °C
Operating
mode
Cooling Cooling Healthy
Dehumidification
Heating
Indoor FAN
Speed
High High High High
Setting Temperature
22°C2 2 °C2 3 °C2 4 °C
Test
operation
During
the TEST
OPERATION,
the unit
operates
in
cooling
mode at
high
speed
fan,
regardless
of room
temperature
and resets in 18 minutes.
During
test
operation,
if remote controller
signal
is
received,
the unit
operates
as remote controller sets.
If
you
want to use this
operation, open
the front
panel upward
and Press the
power
button let it be
pressed
for about
3 seconds.
If
you
want to
stop
the
operation, re-press
the button.
Forced
Operation
Helpful
information
Fan
speed
and
cooling
capacity.
The
cooling
capacity
indicated in the
specification
is the value when the fan
speed
is set to
high,
and the
capacity
will be lower at low or medium fan
speed.
High
fan
speed
is recommended when
you
wish to cool the room
quickly.
In case the
power
comes on
again
after a
power
failure,
Auto
Restarting
Operation
is the function to
operate procedures automatically
to the
previous
operating
conditions.
So there is no need of
activating
this function
by
pressing
any key
or button.
In the initial
mode,
the fan
operates
at a low
speed
and the
compressor
starts 2.5~3 minutes later.
As the
compressor
starts,
the fan
speed
also resumes its
previous
setting
mode.
Auto restart