Operation Manual

Setting
the VCR
output
channel
10
Your TV set receives the video recorder
signal
like another TV station. So
you
have to
select a
programme
number for the video recorder.
Take care to select this
programme
number,
whenever
you
control the video
recorder,
or watch a
recording. Only
if
you
have selected this
programme
number,
which we
call video
programme
number,
you
will see the
picture
from the video recorder on the
screen.
If
you
connect a monitor or a TV set
equipped
with audio and video
terminals,
this
adjustment
will not
necessary.
Consult the
operating
instructions of
your
TV set.
Connect the video recorder as described in the section on Connections
(see
on
previous page).
Setting
the
output
channel of the VCR
SETTING THE VIDEO CHANNEL WITH
PLAYBACK
The
output
channel of the video recorder is set at UHF channel 36.
1 Turn on the TV set and the video recorder.
2
Play any
video cassette
tape
on
your
video recorder.
3
Select the correct channel
(36)
on
your
TV set.
And then
you
will see the
picture being played
in video recorder.
(Note
-
You will need to look at the instruction manual for
your
TV set if
you
do
not know how to do
this.)
SETTING THE VIDEO CHANNEL WITH
OSD
(ON
SCREEN
DISPLAY)
1 Turn on the TV set and the video recorder.
2
Repeat
above No. 3. And then
you
will see a blue
background picture
on the TV
screen.
3
Store this channel in an unused
programme
number on
your
TV set.
Changing
the transmitter channel
If the channel 36 is
already occupied
at
your
TV
set,
or if the
picture
is
distorted,
you
can
change
the transmitter channel of the video recorder.
1 Select an
unoccupied
channel between 22 and 68 on
your
TV set.
2
During power
off mode
(only
clock
display) press
the PROG. " " or " " buttons
on the VCR for more than 4 seconds.
Then,
"CH36" will be
displayed
on the VCR's
display.
3
Press the PROG. " " or " " buttons on the VCR to select another video channel
e.g.
between channels 22 and 68.
4 Press the
" "
button when
you
have finished.