Owner’s Manual

16 INSTALLATION

f UL-listed Conduit Connector

g Black Wires

h Junction Box

i White Wire (No Connection)

Installing the Cooktop Unit

1 Visually inspect the cooktop for damage.

Make sure all cooktop screws are tight (see

below for locations).

2 Check and prepare the installation location.

•See Dimensions and Clearances.

3 Carefully lower the cooktop into the

countertop cutout, making sure not to trap

any wires.

NOTE

• Do not use caulking compound. The cooktop

must be removable, should service be required.

4 Attach the retainer brackets a to the bottom

of the cooktop; then snug the bolts against

the bottom of the countertop as shown.

NOTE

• The retainer brackets MUST be installed to meet

local codes or, in their absence, with the National

Electrical Code ANSI/NFPA No. 70, latest edition.

a Cooktop

b Countertop

c Bolt

d Retainer Brackets

e Type A Screw

Final Check

Perform a final operational check of the cooktop,

making sure the cooktop powers on properly and

that each cooking zone operates correctly. Refer to

the Operating Instructions in this guide for details.

3 Screws (Same Both Side)

30" Cooktop: 3 Screws (Same Both Side)

36" Cooktop: 4 Screws (Same Both Side)

en-us_main.book.book Page 16 Monday, November 20, 2023 1:51 PM