Owner's Manual

ManualsBrandsLG ManualsProjectorsCF3DA

Function

Network Settings

< Notes >

▪ Use a standard LAN cable with this projector. (Cat5, Cat5E, or Cat6 with an RJ45 connector)

▪ Modem reconfiguration may cause network connection problems. In this case, turn off the modem and disconnect it

from the projector; then turn on the modem again.

▪ To connect to a wireless router, a router that supports wireless connection is necessary; the wireless connection func-

tion of the corresponding router must also be activated.

▪ To connect to a wireless router, verify the SSID and security settings of the wireless router. Please refer to the user

guide of the corresponding router regarding SSID and security settings of the wireless router.

▪ The projector may not work properly if network devices (wire/wireless router or hub, etc.) are incorrectly set up. Be

sure to install the devices correctly by referring to their user guides before configuring network settings.

▪ The Ad-hoc connection method will not work properly with every computer. We recommend you use standard network-

ing by connect devices to a router.

▪ The connection method may vary according to the manufacturer of the wireless router.

1. Press the MENU button, then go to OPTION with the ∧, ∨, ＜,

＞ buttons and press OK

◉

Press the ∧, ∨ buttons to go to High Altitude and press OK ◉.

3. Press the ＜, ＞ buttons to select On and press OK

◉

ꔈPress the BACK button to exit the menu screen.

High Altitude

OPTION

Menu Language : ENGLISH

Blank Image : Black

Camera Calibration

Lamp Mode : Normal

High Altitude : Off ꔉ

Network Setting

Set ID : 1

Input Label

Power Sound : Off

ꔂ Move ꔉ OK

* High Altitude is used at environments higher than 4,000 feet.

1. Press the MENU button, then go to OPTION with the ∧, ∨, ＜, ＞ but-

tons and press OK

◉

2. Press the ＜, ＞ buttons to go to Lamp Mode.

3. Press the ∧, ∨ buttons to select an option.

ꔈ If room temperature is over

35°C

or the 3D video is working, this is not

available.

ꔈ You can select this function through the MENU button.

ꔈ Press the BACK button to exit the menu screen.

To adjust the brightness of the screen,