Owner's Manual

E-9
Device Drivers
When
using
Windows 98/95 or Window NT
Workstation
Ver.
4.0,
the
installation
of
any
software
driver or
special
device is
not
required.
This CD-ROM drive is
supplied
with MS-DOS drivers on a 31/2-inch
floppy
disk.
These drivers are
required
to use the CD-ROM drive in DOS and Windows 3.1.
Drivers for other
Operating Systems
are not
normally required
or available as
they usually
have an
generic
IDE,
E-IDE/ATAPI CD-ROM driver built
in;
Windows
95, 98,
NT 3.51 and
higher
and OS/2
Warp
3.0 are such
examples.
If it is
necessary
to edit
any
file
manually,
first make a
backup copy
on a
floppy
disk,
then edit the
original
file,
save it to
your
hard
drive, exit,
and re-boot the
PC to ensure the
change
will be
implemented.
Running
the Install
Program
(MS-DOS Installation)
1. Insert the diskette into the
appropriate
drive with DOS
booting.
2. Go to the
floppy
drive
by typing
A: or B: at the DOS
prompt,
as
appropriate.
3.
Type
the word INSTALL and
press [ENTER].
4. The INSTALL
program
will
begin loading.
When
loading
is
complete,
the
INSTALL
program
identification will
appear
on screen.
5. Follow the instructions on screen.
6. When installation is
complete,
remove the diskette and reboot
your
PC.
For Windows 98/95 Users
[ In order to ensure normal drive
operation, please
check the
following:
?
The drive is
displayed
in
[control panels]-[system]-[device manager]-[CD-ROM]
?
32-bit is
displayed
in
[control panels]-[system]-[performance]
[ If the drive is not
recognized by your computer, please
check the
following
items.
?
If a indicator is
displayed
on the IDE controller in
[control panels]-
[system]-[device manager]-[harddisk controller], you
will need to contact
your
PC's manufacturer or the motherboard's manufacturer and
get
the
appropriate
IDE controller driver.
[ Run ADD NEW HARDWARE in Control Panel to let PC search
again
for new
device.