Owner's Manual

E-8
4.
Adjust
the Master/Slave
jumpers
on the back of the CD-ROM drive as
necessary.
Connect the CD-ROM drive to the IDE
ports
of
your
motherboard. In
general,
the hard drive will be in
Primary
IDE
port
and Master device for
booting
the
operating system.
There are two
possible
alternate connection for CD-ROM
drive installation.
A)
When
using
a
Primary
IDE
port
If
you
need to connect
your
CD-ROM drive to the same
Primary
IDE
port,
the
CD-ROM drive should be set to Slave
position.
B)
When
using
a
Secondary
IDE
port
You can also connect CD-ROM drive to the
Secondary
IDE
port
and set to
Master
position.
5. When the installation of the drive unit is
complete, replace
the
computer
cover.
6. Reconnect the
computer power
cord and turn on the
computer.
DIGIT
AL
U
DIO
DG
GL
1
2
R
+5+
1
2
GND
UDIO
ANLOG
E
POWER
DIGIT AL
UDIO
DG
GL
CSM
39
1
2
0
R
+5
+1
2 GND
UDIO
AN
LOG
INTERFACE
POWER
DIGIT AL
UDIO
DG
GL
1
2
R
+5
+12
GND
UDI
ANAL
CE
POWER
Primary
connector
Master drive
(Booting
hard
disk)
Slave drive
(CD-ROM drive)
Master drive
(Booting
hard
disk)
Master drive
(CD-ROM drive)
Motherboard
Secondary
connector
Primary
connector
Slave drive
(Other
IDE
drive)