Owner's Manual

E-9
Device Drivers
When
using
Windows 95/98/2000 or Window NT
Workstation
Ver.
4.0,
the
installation
of
any
software
driver or
special
device is
not
required.
This CD-ROM drive is
supplied
with MS-DOS drivers on a 31/2-inch
floppy
disk.
These drivers are
required
to use the CD-ROM drive in DOS and Windows 3.1.
Drivers for other
Operating Systems
are not
normally required
or available as
they usually
have an
generic
IDE,
E-IDE/ATAPI CD-ROM driver built
in;
Windows
95, 98, 2000,
NT 3.51 and
higher
and OS/2
Warp
3.0 are such
examples.
If it is
necessary
to edit
any
file
manually,
first make a
backup copy
on a
floppy
disk,
then edit the
original
file,
save it to
your
hard
drive, exit,
and re-boot the
PC to ensure the
change
will be
implemented.
Running
the Install
Program
(MS-DOS Installation)
1. Boot to the DOS
prompt.
2. Insert the driver diskette into the
appropriate
drive.
3. Go to the
floppy
drive
by typing
A: or B: at the DOS
prompt,
as
appropriate.
4.
Type
the word INSTALL and
[Enter].
5. The Install
program
will
begin lodaing
and
you
will
prompted
to
accept
the default
directory
of C:\DVDROM
press [Enter]
to
accept (suggested)
or edit the
path
then
press [Enter].
6. When installation is
complete,
remove the diskette and reboot
your
PC.
(Note:
You must have a
Config.sys
and an Autoexec.bat file on
your
hard drive
for the install
program
to add the
necessary
command
lines.)
For Windows 98/95 Users
[ In order to ensure normal drive
operation, please
check the
following:
?
The drive is
displayed
in
[control panels]-[system]-[device manager]-[CD-ROM]
?
32-bit is
displayed
in
[control panels]-[system]-[performance]
[ If the drive is not
recognized by your computer, please
check the
following
items.
?
If a indicator is
displayed
on the IDE controller in
[control panels]-
[system]-[device manager]-[harddisk controller], you
will need to contact
your
PC's manufacturer or the motherboard's manufacturer and
get
the
appropri-
ate IDE controller driver.
[ Run ADD NEW HARDWARE in Control Panel to let PC search
again
for new
device.