Installation guide

Installation Manual 9
Installation
ENGLISH
Sticking the Installation Guide Map and Fixing Indoor Unit
4) Drill the piercing part for connecting pipe as
diameter 50mm. (In case of piercing rear surface)
10m
m
INSTALLATION GU
6) First, drive the two points of the upper parts by
screws. (Leave 10mm for hanging product)
INSTALLATION GUIDE MAP
IN
S
T
A
IIA
T
IO
N
G
U
ID
E
M
A
P
INSTALLATION GUIDE M
AP
1) Put an Installation Guide Map on the desired
surface.
3) Make a hole with diameter of 6mm and depth of
5) Drive the plastic anchors into drilled points.
7) Hang the hole of product at the upper screws.
(In this time, remove the map)
(Falling attention)
9) Check the fixed product with light power.
2) Look at suited horizon by horizontal meter on
the horizontal setting line, and fix lightly the
map by adhesive tape.
8) Drive the lower parts after facing the hole of
product with plastic anchors, and fix completely
the upper screws.
10) Drive the lower parts after facing the hole of
product with plastic anchors, and fix completely
the upper screws.
Horizontal meter
IN
S
T
A
L
L
A
T
IO
N
G
U
ID
E
M
A
P
Plastic anchors
IN
S
T
A
L
L
A
T
IO
N
G
U
ID
E
M
A
P
Hanger hole
(Rear side of
product)
Plastic anchors