Owner's Manual

3030
Problem
The display shows OE
code. (Water is not
pumped away.)
• The drain hose is kinked.
• The filter is clogged.
• Motor trouble.
(Washing motor or Drain motor)
The display shows IE
code.
• Water is not supplied.
• Water tap is not opened.
• Water sensor has trouble.
The display shows EI
code.
(Automatically Drain
pump operated.)
• Straighten hose(s).
• Clean the filter.
• If you can not solve the
problem, call for
service.
• Check the water tap.
• If you can not solve the
problem, call for
service.
• Close the water tap
and unplug the power
plug.
• Call for service.
• Water is leaking from the hose
connections.
• Damage to the unit has been
caused by a water leak.
The display shows FE
code. (Automatically
Drain pump operated.)
• Excessive water is supplied, which
is more than the normal water level.
• There is a problem with the inlet
valve.
The display shows HE
code.
• The water heater circuit is damaged.
The display shows tE
code.
The display shows LE
code.
• Thermistor trouble or very high inlet
water temperature.
• Motor trouble.
SolutionPossible Causes
31
Code Description
The display shows
PF code
This indicates there was a power failure. This function protects
the dishwasher in the event that the power goes out or the power
to the unit is disrupted. When power is returned, and a button is
pushed, this will display for 10 seconds and then go away.
The display shows
Cd code
Cd means Cool-dry. This is an additional drying cycle to assist
drying performance. This cycle runs for a further 60 minutes after
the course has finished. It can be interrupted at any time by
opening the door.
The display shows
CL code
CL means Child-Lock. This function is used to lock or unlock
the control buttons to prevent all the settings from being changed
by a child. It can only be activated during the wash cycle.
The display shows
F code
When the unit is displaying F, the sensor is measuring the
water clarity. After 5 minutes of sensing (except draining and
filling), the unit's display will then show the processing time.
The display shows
numbers between 1 ~ 19
Odor
Buzzing sound.
(High Temperature Alarm)
This is not an error code, but indicates the setting of the delay
start. To cancel the function, turn the power off. To change the
course and option, open the door and select another course and
option. Countdown will then continue after door is closed again.
If the dishwasher is not used daily, we recommend to run a
Quick cycle once or twice a day until you have a full load.
In case odor still persists, run a vinegar rinse through a Auto
cycle by putting 2cup(500ml) of white vinegar in an upright
measuring cup in the lower rack, without detergent.
We recommend to maintain according to the USER
MAINTENANCE INSTRUCTIONS.
This is not an error. When you open the door right after heating
wash, rinse or dry, buzzing sound would keep on ringing for
safety if the inside is heated.
•These are not error codes indicating a malfunction.
TROUBLE SHOOTING GUIDETROUBLE SHOOTING GUIDE
Before calling for service
Before calling for service