Owner's Manual

Reference
Troubleshooting
Check the
following guide
for the
possible
cause of a
problem
before
contacting
service.
Symptom
No
power.
The
power
is
on,
but
the DVD
player
does
not work.
No
picture.
No sound.
The
picture
is
poor.
The DVD
player
does
not start
playback.
.
The remote control
does not work
properly.
Video
tape
cannot be
inserted.
No Hi-Fi sound
No NICAM sound
recording
Cause
The
power
cord is disconnected.
No disc is inserted.
The TV is not set to receive this unit's
signal output.
The video cable is not connected
securely.
Unit
output setting
and TV resolution
capabilites
mismatch.
The
equipment
connected with the
audio cable is not set to receive DVD
signal output.
The audio cables are not connected
securely.
The
power
of the
equipment
connected
with the audio cable is turned off.
The Audio
option
is set to the
wrong
position.
The disc is
dirty.
The TV channels are not tuned in
properly.
An
unplayable
disc is inserted.
The disc is
placed upside
down.
The disc is not
placed
within the
guide.
The disc is
dirty.
The
Rating
level is set.
There is an obstacle in the
path
of the
remote control and this unit.
The batteries in the remote control are
exhausted.
Is the cassette
compartment empty?
Audio mode is not set
properly.
NICAM mode is not set
properly.
Correction
Plug
the
power
cord into the wall outlet
securely.
Insert a disc.
Select the
appropriate
video
input
mode
on the TV so the
picture
from the this
unit
appears
on the TV screen.
Connect the video cable into the
jacks
securely.
Check TV
capability.
Check mode of connections
(eg.
S-Video,
Components etc.).
Check unit Resolution
setting according
to TV
capability
and mode of
connection.
Select the correct
input
mode of the
audio receiver so
you
can listen to the
sound from the this unit.
Connect the audio cable into the
jacks
securely.
Turn on the
equipment
connected with
the audio cable.
Set the Audio
option
to the correct
posi-
tion,
then turn on the DVD
player again
by pressing
POWER.
Clean the disc.
Check
tuning, carry
out
tuning again.
Insert a
playable
disc.
(Check
the disc
type
and
Regional code.)
Place the disc with the
playback
side
down.
Place the disc on the disc
tray correctly
inside the
guide.
Clean the disc.
Cancel the
Rating
function or
change
the
rating
level.
Remove the obstacle.
Replace
the batteries with new ones.
Eject
the
tape
in.
Select "STEREO"
by repeatedly pressing
"AUDIO" on the remote control.
Make sure NICAM in the menu is set to
AUTO for the station to be recorded.