Owner’s Manual
Table Of Contents
- PRODUCT FEATURES
- SAFETY INSTRUCTIONS
- PRODUCT OVERVIEW
- INSTALLATION
- Installation Overview
- Product Specifications
- Installation Location Requirements
- Clearances
- Leveling the Dryer
- Reversing the Door
- Installing the Side Vent Kit
- Stacking the Dryer
- Venting the Dryer
- Connecting Gas Dryers
- Connecting Electric Dryers
- Special Electrical Requirements
- Final Installation Check
- Installation Test (Duct Check)
- OPERATION
- SMART FUNCTIONS
- MAINTENANCE
- TROUBLESHOOTING
- WARRANTY
- CARACTÉRISTIQUES DU PRODUIT
- CONSIGNES DE SÉCURITÉ
- APERÇU DU PRODUIT
- INSTALLATION
- Aperçu de lʼinstallation
- Caractéristiques du produit
- Conditions requises pour l'emplacement d'installation
- Dégagements
- Mise à niveau de la sécheuse
- Changement du côté de la porte
- Installation de la ventilation latérale.
- Superposition de la sécheuse
- Ventilation de la sécheuse
- Raccordement des sécheuses au gaz
- Raccordement des sécheuses électriques
- Conditions de l'alimentation particulières
- Vérification finale de l'installation
- Essai d'installation et vérification des conduits d'évacuation
- FONCTIONNEMENT
- FONCTIONS INTELLIGENTES
- ENTRETIEN
- DÉPANNAGE
- GARANTIE
15INSTALLATION
ENGLISH
Reversing the Door
Tools Required
• Phillips screwdriver
• Large at blade screwdriver (recommended for
hinge screws if they are tight or your Phillips
screwdriver is worn)
• Small at blade screwdriver (for lifting out parts)
WARNING
To reduce the risk of damage to the dryer,
property damage or personal injury, follow
basic precautions, including the following:
• Support the door with a stool or box that ts
under the door, or have an assistant support the
weight of the door.
• Avoid dropping the door.
• Unplug the dryer or turn off power at the main
circuit breaker before beginning door reversal.
• Always reverse the door BEFORE stacking the
dryer on top of the washer.
Door Reversal Instructions
The instructions here are for changing the door swing
from a right to a left side hinge. If the door has been
reversed, and it is necessary to change it back, use
care when following these instructions. Some of
the illustrations and the left/right references will be
reversed, and you will need to read the instructions
carefully.
WARNING
• Be sure to support the weight of the door before
removing the hinge screws.
1
Open the door and remove the two decorative
screws, two latch screws, and the latch on the
catch side with a screwdriver. Save these for
step 4.
2
While supporting the door, remove the 2 screws
on the door hinge. Remove the door.
3
Turn the door upside down and line up the
holes in the hinge with the holes in the cabinet.
Reinstall the door with the screws removed in
step 2.
WARNING
• Be sure to support the weight of the door before
installing the hinge screws.
4
Install the two decorative screws, the latch,
and two latch screws removed in step 1 on the
opposite side from which they were removed.
5
Check that the door closes properly.