Owner’s Manual

42 OPERATION
Energy Saver
This option helps to reduce the energy
consumption of the Normal cycle, depending on
the load size. When the Energy Saver option is
selected, the cycle begins with an air dry section
and the drying time is increased.
NOTE
•The Energy Saver option is turned on by default
in the Normal cycle.
• Turning the Energy Saver option off changes
the default cycle to the last cycle used. To return
to the default settings, turn the Energy Saver
option on.
More Time / Less Time
Use these buttons to increase or decrease drying
time in 5 minute increments when you use manual
drying cycles such as Speed Dry, Air Dry and Time
Dry.
Wrinkle Care
Selecting this option will tumble the load
periodically for up to 3 hours after the selected
cycle, or until the door is opened. This is helpful in
preventing wrinkles when you are unable to
remove items from the dryer immediately.
Press the Wrinkle Care button before you start a
drying cycle.
NOTE
• When the option is turned on, a rectangle with a
dashed line and
ENd appears on the display until
the feature is off.
• When the option is turned on, only the Power
button works after the drying cycle ends.
• To select the option after starting a cycle, pause
the cycle, set the option, and press Start/Pause.
• Always turn off the appliance before unloading
the clothes.
Drum Light
The drum is equipped with a white LED light that
illuminates when the dryer is turned on. This light
automatically turns off when the door is closed
and the cycle starts.
• Press and hold the Wrinkle Care button for 3
seconds during the cycle to turn on the drum
light.
• The drum light will turn off automatically after 4
minutes.
Damp Dry Signal
When this option is selected, the appliance signals
when the load is approximately 80% dry. This
allows you to remove faster-drying lightweight
items or items that you would like to iron or hang
while they are still slightly damp.
Press the Damp Dry Signal button before you
start a drying cycle.
Control Lock
Use this function to disable the controls. This
function can prevent children from changing
cycles or operating the dryer.
NOTE
• The function does not lock the door.
• Once this function is set, all buttons are locked
except the Power button.
• When the controls are locked,
CL and the
remaining time are alternately shown on the
display during the dry cycle.
• Turning off the power will not reset this function.
You must deactivate this function before you can
access any other options and functions.
Locking/Unlocking the Control Panel
1 Turn on the power.
2 Press and hold the Damp Dry Signal button
for 3 seconds to activate/deactivate this
function.
• When the function is deactivated, a chime will
sound and the remaining time for the current
cycle will reappear on the display.