Owner's Manual

Hookup and

Settings

Connecting an Antenna

or Cable TV

Antenna

Disconnect the antenna from the rear of the TV and

identify the antenna cable. If it is a round 75 ohm

coaxial cable connect it directly to the jack marked

ANTENNA IN on your Recorder. If your antenna cable

is flat connect it to a 300-ohm to 75-ohm antenna

adaptor (not supplied) and slip the adaptor over the

ANTENNA IN jack. Don’t attempt to screw it into to the

Recorder.

Cable TV:

If your cable connection has no converter or

descrambler, unscrew the cable from your TV and

attach it to the ANTENNA IN jack on the Recorder.

If a converter is required connect a coaxial cable from

the wall jack to the IN connector on the converter, and

a coaxial cable from the OUT connector on the

converter to the ANTENNA IN on your Recorder. This

cable hookup permits both TV and Recorder

operation.

To view or record a CATV channel

1. Tune the TV to the Recorder output channel (CH 3

or 4).

2. Set the Recorder channel selector to the cable

output channel. (Example: CH3)

3. Select a channel using the cable converter.

Notes:

• With this connection, you cannot record one channel

while viewing another.

• If you are using a cable box to tune channels, it is not

necessary to do Auto Channel Set.

Rear of Recorder

Antenna Antenna

OR OR