Owner’s Manual

E-8
Installing
the Drive
Before
installing
the
drive,
turn off the
system power.
Follow the
steps
below to install the
DVD-ROM drive:
1. Remove the cover from
your computer system.
Refer to manual for the
computer
for
details about
removing
the cover.
2.
Adjust
the Master/Slave
jumpers
on the back of the DVD-ROM drive as
necessary.
Connect the DVD-ROM drive to the IDE
port
of
your
motherboard. In
general,
the hard
drive will be in
Primary
IDE
port
and Master device for
booting
the
operating
system.
There are two
possible
alternate connection for DVD-ROM drive installation.
A)
When
using
a
Primary
IDE
port
If
you
need to connect
your
DVD-ROM drive to the same
Primary
IDE
port,
the DVD-ROM
drive should be set to Slave
position.
B)
When
using
a
Secondary
IDE
port
You can also connect DVD-ROM drive to the
Secondary
IDE
port
and set to Master
posi-
tion.
D
IGITAL
ANALOG
E
POWER
D
R
CS
S
GL
G
1+5+12
GND
2
AUDIO
AUDIO
DIGITAL
AN
LOG
I
NTERFACE
POWER
DR
CSM
SLA
GL
G3 9
1
+5
+12
GND
40
2
AUDIO
AUDIO
DIGITAL
N
LOG
POWER
DR
CS
SL
GL
G
1
+5
+12
GND
2
AUD
I
O
AUDIO
Master drive
(Booting
hard
disk)
Master drive
(Booting
hard
disk)
Master drive
(DVD-ROM drive)
Slave drive
(Other
IDE
drive)
Motherboard
Primary
connector
Primary
connector
Secondary
connector
Slave drive
(DVD-ROM drive)