User manual

HAPTER

| Class of Service

Layer 2 Queue Settings

– 126 –

ES-2000 Series

◆ If the output port is an untagged member of the associated VLAN,

these frames are stripped of all VLAN tags prior to transmission.

PARAMETERS

These parameters are displayed:

◆ Interface – Displays a list of ports or trunks.

◆ CoS – The priority that is assigned to untagged frames received on the

specified interface. (Range: 0-7; Default: 0)

WEB INTERFACE

To configure the queue mode:

1. Click Traffic, Priority, Default Priority.

2. Select the interface type to display (Port or Trunk).

3. Modify the default priority for any interface.

4. Click Apply.

Figure 65: Setting the Default Port Priority

SELECTING THE

QUEUE MODE

Use the Traffic > Priority > Queue page to set the queue mode for the

egress queues on any interface. The switch can be set to service the

queues based on a strict rule that requires all traffic in a higher priority

queue to be processed before the lower priority queues are serviced,

Shaped Deficit Weighted Round-Robin (SDWRR) queuing that specifies a

scheduling weight for each queue. SDWRR is labelled WRR in the menu. It

can also be configured to use a combination of strict and weighted

queuing.

COMMAND USAGE

◆ Strict priority requires all traffic in a higher priority queue to be

processed before lower priority queues are serviced.

◆ The WRR algorithm used by this switch is known as Shaped Deficit

Weighted Round Robin (SDWRR).