User manual

C HAPTER 14 | Security Measures
Access Control Lists
– 177 –
ES-2000 Series
SETTING THE ACL
NAME AND TYPE
Use the Security > ACL (Configure ACL - Add) page to create an ACL.
PARAMETERS
These parameters are displayed:
◆ ACL Name – Name of the ACL. (Maximum length: 15 characters)
◆ Type – The following filter modes are supported:
■
IP Standard: IPv4 ACL mode filters packets based on the source
IPv4 address.
■
IP Extended: IPv4 ACL mode filters packets based on the source
or destination IPv4 address, as well as the protocol type and
protocol port number. If the “TCP” protocol is specified, then you
can also filter packets based on the TCP control code.
■
MAC – MAC ACL mode filters packets based on the source or
destination MAC address and the Ethernet frame type (RFC 1060).
WEB INTERFACE
To configure the name and type of an ACL:
1. Click Security, ACL.
2. Select Configure ACL from the Step list.
3. Select Add from the Action list.
4. Fill in the ACL Name field, and select the ACL type.
5. Click Apply.
Figure 101: Creating an ACL