User manual

C HAPTER 15 | Basic Administration Protocols
Link Layer Discovery Protocol
– 211 –
ES-2000 Series
WEB INTERFACE
To configure LLDP interface attributes:
1. Click Administration, LLDP.
2. Select Configure Interface from the Step list.
3. Select Configure General from the Action list.
4. Select an interface from the Port or Trunk list.
5. Set the LLDP transmit/receive mode, specify whether or not to send
SNMP trap messages, and select the information to advertise in LLDP
messages.
6. Click Apply.
Figure 121: Configuring LLDP Interface Attributes
CONFIGURING LLDP
I
NTERFACE CIVIC-
ADDRESS
Use the Administration > LLDP (Configure Interface – Add CA-Type) page
to specify the physical location of the device attached to an interface.
COMMAND USAGE
◆ Use the Civic Address type (CA-Type) to advertise the physical location
of the device attached to an interface, including items such as the city,
street number, building and room information. The address location is
specified as a type and value pair, with the civic address type defined in