User manual

C HAPTER 15 | Basic Administration Protocols
Simple Network Management Protocol
– 245 –
ES-2000 Series
Figure 146: Configuring Remote SNMPv3 Users
To show remote SNMPv3 users:
1. Click Administration, SNMP.
2. Select Configure User from the Step list.
3. Select Show SNMPv3 Remote User from the Action list.
Figure 147: Showing Remote SNMPv3 Users
SPECIFYING TRAP
MANAGERS
Use the Administration > SNMP (Configure Trap) page to specify the host
devices to be sent traps and the types of traps to send. Traps indicating
status changes are issued by the switch to the specified trap managers.
You must specify trap managers so that key events are reported by this
switch to your management station (using network management
software). You can specify up to five management stations that will receive
authentication failure messages and other trap messages from the switch.
COMMAND USAGE
◆ Notifications are issued by the switch as trap messages by default. The
recipient of a trap message does not send a response to the switch.