User manual

C HAPTER 15 | Basic Administration Protocols
Simple Network Management Protocol
– 248 –
ES-2000 Series
◆ Local User Name – The name of a local user which is used to identify
the source of SNMPv3 trap messages sent from the local switch.
(Range: 1-32 characters)
If an account for the specified user has not been created (page 241),
one will be automatically generated.
◆ Remote User Name – The name of a remote user which is used to
identify the source of SNMPv3 inform messages sent from the local
switch. (Range: 1-32 characters)
If an account for the specified user has not been created (page 243),
one will be automatically generated.
◆ UDP Port – Specifies the UDP port number used by the trap manager.
(Default: 162)
◆ Security Level – When trap version 3 is selected, you must specify
one of the following security levels. (Default: noAuthNoPriv)
■
noAuthNoPriv – There is no authentication or encryption used in
SNMP communications.
■
AuthNoPriv – SNMP communications use authentication, but the
data is not encrypted.
■
AuthPriv – SNMP communications use both authentication and
encryption.
WEB INTERFACE
To configure trap managers:
1. Click Administration, SNMP.
2. Select Configure Trap from the Step list.
3. Select Add from the Action list.
4. Fill in the required parameters based on the selected SNMP version.
5. Click Apply
Figure 148: Configuring Trap Managers (SNMPv1)