User manual

C HAPTER 3 | Using the Web Interface
Navigating the Web Browser Interface
– 39 –
ES-2000 Series
MAIN MENU Using the onboard web agent, you can define system parameters, manage
and control the switch, and all its ports, or monitor network conditions. The
following table briefly describes the selections available from this program.
Table 4: Switch Main Menu
Menu Description Page
System
General Provides basic system description, including contact information 47
Switch Shows the number of ports, hardware version, power status, and
firmware version numbers
48
IP Sets the IPv4 address for management access 271
Capability Enables support for jumbo frames;
shows the bridge extension parameters
50,
51
File 52
Copy Allows the transfer and copying files 52
Set Startup Sets the startup file 55
Show Shows the files stored in flash memory; allows deletion of files 56
Time 57
Configure General
Manual Manually sets the current time 57
SNTP Configures SNTP polling interval 58
Configure Time Server Configures a list of SNTP servers 59
Configure Time Zone Sets the local time zone for the system clock 60
CPU Utilization Displays information on CPU utilization; 61
Memory Status Shows memory utilization parameters 62
Reset Restarts the switch immediately, at a specified time, after a
specified delay, or at a periodic interval
62
Interface 65
Port 65
General
Configure by Port List Configures connection settings per port 65
Configure by Port Range Configures connection settings for a range of ports 68
Show Information Displays port connection status 68
Mirror 69
Show Shows the configured mirror sessions 69
Add Sets the source and target ports for mirroring 69
Statistics Shows Interface, Etherlike, and RMON port statistics 71
Chart Shows Interface, Etherlike, and RMON port statistics 71
Cable Test Performs cable diagnostics for selected port to diagnose any cable
faults (short, open etc.) and report the cable length
75