User manual

C HAPTER 5 | Interface Configuration
Port Configuration
– 70 –
ES-2000 Series
COMMAND USAGE
◆ Traffic can be mirrored from one or more source ports to a destination
port on the same switch (local port mirroring as described in this
section).
◆ Monitor port speed should match or exceed source port speed,
otherwise traffic may be dropped from the monitor port.
PARAMETERS
These parameters are displayed:
◆ Source Port – The port whose traffic will be monitored.
(ES-2026/P: 1-26, ES-2024G/P: 1-24)
◆ Target Port – The port that will mirror the traffic on the source port.
(ES-2026/P: 1-26, ES-2024G/P: 1-24)
◆ Type – Allows you to select which traffic to mirror to the target port, Rx
(receive), Tx (transmit), or Both. (Default: Rx)
WEB INTERFACE
To configure a local mirror session:
1. Click Interface, Port, Mirror.
2. Select Add from the Action List.
3. Specify the source port.
4. Specify the monitor port.
5. Specify the traffic type to be mirrored.
6. Click Apply.
Figure 23: Configuring Local Port Mirroring