User manual

C HAPTER 5 | Interface Configuration
Trunk Configuration
– 85 –
ES-2000 Series
To show the connection parameters for a dynamic trunk:
1. Click Interface, Trunk, Dynamic.
2. Select Configure Trunk from the Step list.
3. Select Show from the Action list.
Figure 37: Showing Connection Parameters for Dynamic Trunks
To show the port members of dynamic trunks:
1. Click Interface, Trunk, Dynamic.
2. Select Configure General from the Step list.
3. Select Show Member from the Action list.
Figure 38: Showing Members of Dynamic Trunks
DISPLAYING LACP
P
ORT COUNTERS
Use the Interface > Trunk > Dynamic (Configure Aggregation Port - Show
Information - Counters) page to display statistics for LACP protocol
messages.
PARAMETERS
These parameters are displayed:
Table 6: LACP Port Counters
Parameter Description
LACPDUs Sent Number of valid LACPDUs transmitted from this channel group.
LACPDUs Received Number of valid LACPDUs received on this channel group.
Marker Sent Number of valid Marker PDUs transmitted from this channel
group.
Marker Received Number of valid Marker PDUs received by this channel group.