User manual

HAPTER

| VLAN Configuration

IEEE 802.1Q VLANs

– 98 –

ES-2000 Series

Edit Member by Interface

All parameters are the same as those described under the preceding

section for Modify VLAN and Member Ports.

Edit Member by Interface Range

All parameters are the same as those described under the earlier section

for Modify VLAN and Member Ports, except for the items shown below.

◆ Port Range – Displays a list of ports. (ES-2026/P: 1-26,

ES-2024G/P: 1-24)

◆ Trunk Range – Displays a list of ports. (Range: 1-12)

OTE

The PVID, acceptable frame type, and ingress filtering parameters

for each interface within the specified range must be configured on either

the Edit Member by VLAN or Edit Member by Interface page.

WEB INTERFACE

To configure static members by the VLAN index:

1. Click VLAN, Static.

2. Select Modify VLAN and Member Ports from the Action list.

3. Set the Interface type to display as Port or Trunk.

4. Modify the settings for any interface as required. Remember that

Membership Type cannot be changed until an interface has been added

to another VLAN and the PVID changed to anything other than 1.

5. Click Apply.

Figure 48: Configuring Static Members by VLAN Index