Owner's Manual

5
Listening to CDs
Listening to CDs - More you can do
Searching for a section within a track
Hold ./> on the unit or ./> on the remote control during playback
and release it at the point you want to listen to.
Program list
You can play up to 20 tracks on a CD in order.
1 Insert a CD and wait for it to be read.
2 Press PROGRAM/MEMO.
on the remote control in stop status.
3 Press ./> on the unit
or ./> on the remote control to select a
track.
4 Press PROGRAM/MEMO. again to save and select a next track.
5 Press
BB
/
[]
to play the programmed music files .
6 To clear your selection, press
xx
, PROGRAM/MEMO. and then
xx
.
About MP3/ WMA
MP3/WMA Disc compatibility with this unit is limited as follows:
• Sampling Frequency : 32 - 48 kHz (MP3), 32 - 48 kHz (WMA)
• Bit rate : 32 - 320 kbps (MP3), 40 - 320 kbps (WMA)
• CD-R physical format should be “ISO 9660/ JOLIET”
• If you record MP3/WMA files using the software which cannot create a FILE
SYSTEM, for example “Direct-CD” etc., it is impossible to playback MP3 files.
We recommend that you use “Easy-CD Creator”, which creates an ISO 9660 file system.
• Do not use special letters such as “/ : * ? “ < >”etc.
• Even if the total number of files on the disc has more than 1000, it will only be
shown up to 999
Audio CD and MP3/ WMA CD can be played back in this unit.
1. Open the CD door
2. Insert the CD: Label facing up.
3. Close the CD door
4. Select the CD function:
The display will show the total
number of tracks (files).
5. Start the CD playing
6. To stop a CD playing
ZZ
-
ZZ
FUNC.
BB
/
[]
xx
-
-
-
FUNCTION
BB
/
[]
xx
ON UNIT ON REMOTE
Listening to the radio - More you can do
Looking for radio stations automatically
1 Press and hold ./> on the unit or TUN- / TUN+ on the remote control
for more than 0.5 second.
2 The tuner will scan automatically and stop when it finds a radio station.
Deleting all the saved stations
1 Press and hold PROGRAM/MEMO. on the remote control
for two seconds.
“ERASE ALL” shows.
2 Press PROGRAM/MEMO. on the
remote control
to erase all the saved
stations.
Improveing poor FM reception
Press
BB
/
[]
(MONO/STEREO) on the remote control. This will change the tuner
from stereo to mono and usually improve the reception.
Listening to the radio
Make sure both the FM and AM (optional) aerials are connected.
1. Select either FM or AM (optional)
2. Select the radio station
3. To ‘save’ a radio station:
A preset number will show in the
display.
4. Select the preset number
5. To confirm press: Up to 50 radio
stations can be saved.
6. To select a ‘saved’ station
ON UNIT
FUNC.
./>
-
-
-
-
ON REMOTE
FUNCTION
TUN- / TUN+
PROGRAM/MEMO.
FOLDER•PRESET
PROGRAM/MEMO.
FOLDER•PRESET
FA64-A0U.DRUSLL_ENG 11/16/09 1:29 PM Page 5