Owner's Manual

Connections
7
INTRODUCTION
Speaker System
Connection
Connect the
speakers using
the
supplied speaker
cords
by matching
the colors of the terminals and those of the
cords. To obtain the best
possible
surround
sound,
adjust
the
speaker parameters (distance,
level,
etc.).
RL
L+
-
R+
-
Left
speaker
Right speaker
Red
Red
Black
Notes
?
Be sure to match the
speaker
cord to the
appropriate
terminal on the
components:
+ to + and
--
to --. If the cords
are
reversed,
the sound will be distorted and will lack base.
?
If
you
use front
speakers
with low maximum
input rating, adjust
the volume
carefully
to avoid excessive
output
on
the
speakers.
?
Do not disassemble the front cover of
supplied speaker.
Antenna
(Aerial)
Connections
Connect the
supplied
FM/AM antennas for
listening
to the radio.
?
Connect the AM
loop
antenna to the AM antenna connector.
?
Connect the FM wire antenna
(or
FM "T"
antenna)
to the FM 75Ω/300Ω coaxial connector.
Notes
?
To
prevent
noise
pickup, keep
the AM
loop
antenna
away
from the unit and other
components.
?
Be sure to
fully
extend the FM wire antenna.
?
After
connecting
the FM wire
antenna,
keep
it as horizontal as
possible.
Position
it for the
best
reception
FM indoor
antenna(aerial)
FM external
antenna(aerial)
(not supplied)
FM external
antenna(aerial)
(not supplied)
FM
75
AM
For
AM(MW) reception,
connect
the
loop
antenna
(aerial)
to the
terminal marked AM
AM(MW) loop
antenna
(aerial)
300 coaxial cable
AM
AM
loop
antenna
(aerial)
FM
(Supplied)
OPTICAL
(Digital
audio out
jack)
connection
(OPTIONAL)
Connecting
to an
amplifier equipped
with two channel
analog
stereo or
Dolby
Surround.
Connect the unit's DIGITAL AUDIO OUT
jacks (OPTICAL)
to the
corresponding
in
jack
on
your amplifier.
Use an
optional digital
(optical)
audio cable.
RL
Amplifier
L
R
AUDIO INPUT DIGITAL INPUT
OPTICAL COAXIAL