Owner's Manual
A2
Connecting
the
Monitor
To
set
up
the
monitor,
ensure
that the
power
is
turned
off
to
the
monitor,
computer
system,
and
other
attached
devices,
then
follow
these
steps:
Power
off
both
the
monitor
and
computer.
To
adjust
height
of
your
monitor,
unlock
the
stand
lock
on
top
of
the
stand.
Push
the
stand
lock
at
arrows
shown(figure
A).
Connect
one
end
of
the
monitor
signal
cable
to
the
input
connector
on
the
rear
panel
of
the
monitor.
Connect
the other
end
to
the
15-pin
connector
on
the
real
panel
of
the
computer
and
tighter
the
screws.
Be
sure
the
signal
cable
aligns
with
the
15-
pin
connector.
Connect
the
other
end
of
the
monitor
signal
cable
to
the
rear
panel
of
Macintosh
computer
through
a
Macintosh
adapter
and
then
tighten
screws.
Connect
the
plug
from
the
AC
adapter
into
the
base
of
the
monitor.
Connect
one
end
of
the
AC
power
cord
to
the
AC
adapter
and
the other
end
to
a
properly
grounded
AC
outlet
that
is
easily
accessible
and
close
to
the
monitor
.
Power
on
the
computer,
then
the
monitor.
If
you
see
the
NO
SIGNAL
message,
check
the
signal
cable
and
connectors.
After
using
the
system,
power
OFF
the
monitor,
then
the
computer.
Note
:
If
you
see
the
"OUT
OF
RANGE"
message,
check
to
make
sure
your
system
is
set
to
one
of
the
factory
preset
modes
(see
page
A15),
or
is
set to
a
resolution
and
refresh
rate
within
the
specification
limits
of
this
monitor.
4'
1
2
3
4
5
678
3
1
2
AUDOI
DC
OUT
24V
IBM
MACINTOSH
Power
Cord
AC
adapter
Signal
cable
Stand
Lock
Adapter
15P
D-15P
1
4
2
3
4'
A