REFRIGERATOR OWNER'S MANUAL PLEASE READ THIS OWNER'S MANUAL THOROUGHLY BEFORE OPERATING AND KEEP IT HANDY FOR REFERENCE AT ALL TIMES. INSTALLATION ........................................................... FEATURE CHART OPERATION ...................................................... ............................................................... 2 3 4 Starting Temperature Ice Control Making Defrosting SUGGESTIONS ON FOOD STORAGE CLEANING ..................... ..................................
THIS REFRIGERATOR IS MANUFACTURED WITH GREAT CARE, AND UTILIZES THE LATEST IN TECHNOLOGY. WE ARE CONFIDENT THAT YOU WILL BE FULLY SATISFIED WITH IT'S PERFORMANCE AND RELIABILITY. BEFORE YOU START YOUR REFRIGERATOR, PLEASE READ THIS BOOKLET CAREFULLY. IT PROVIDES EXACT INSTRUCTIONS FOR MAINTENANCE, INSTALLATION, OPERATION AND AND ALSO SUPPLIES SOME USEFUL HINTS. INSTALLATION 1. Select a good location. refrigerator where 5. Clean your Place your 2. Avoid placing the unit sunlight or moisture.
FEATURE CHART Evaporator Drip Tray Collects water during defrosting Ice Tray Thermostat Dial For controlling the temperature refrigerator. in the Shelves Magnetic Door Seal Door Rack Crisper or & Glass lid P.V.C Bar For fruits and (Optional) vegetables.
OPERATION STARTING When your prior If to refrigerator is filling it with fresh operation is interrupted, first installed, allow it 2-3 hours to stabilize at normal operating temperature food. allow a 5 minute delay before restarting. TEMPERATURE CONTROL Your the 4 3 Initially, 5 0 7 To make ice To cubes, fill the ice tray with evaporator. remove ice cubes, hold the tray water and place at its ends and twist gently.
OPERATION DEFROSTING It is necessary to regularly defrost your refrigerator in order to ensure efficient operation. The frost on the surface of the evaporator should not exceed a quarter of an inch(6mm) before defrosting. To defrost, turn the control to '0'. Before you start the proper position. When defrosting is defrosting operation, completed, Turn the control dial to a CAUTION: Never remove the desired position.
CLEANING It is that your refrigerator be kept clean to undesirable odors. Spilled food should be INTERIOR important prevent wiped up immediately, since it may acidify stain plastic surfaces if allowed to settle. Never use metallic abrasive cleaners or with coarse strong alkaline solutions Regular cleaning a baking soda solution. Rinse and WARNING Before you clean, however, remember that damp objects will stick or adhere to extremely cold surfaces.
IMPORTANT WARNINGS DO NOT USE AN EXTENSION CORD If connect the possible, household or lights refrigerator to its own causing an overload from individual electrical outlet to that could cause a power prevent it and other appliances outage. POWER CORD REPLACEMENT If the supply its service cord is ABOUT GROUNDING In the event of an it must be damaged, replaced by a special cord or assembly from the manufacturer or agent.
REPOSITIONING THE DOOR HINGE Your refrigerator is designed with a reversible door so that reposition the door hinge as necessary at the outset since To change the door hinge please refer to the diagram (Option) is may open from either left or right. It is best to it is inconvenient to do so later. below and proceed as follows:--- F G H CE D A B 1. Remove all loose 2. the Carefully lay Take care not to 3. Unscrew and fittings remove 4. Remove the Lower 5. Remove the 6.
REPOSITIONING THE DOOR HINGE 8. Unscrew the 9. Now 10. 11. secure the Replace Carefully and Upper Hinge pin (G) the Lower Hinge (D) Adjustable stand the Foot appliance screw it into the to the cabinet (A), setting up, (you it at using opposite side hole in the the 2xBolts approximately (Option) top of the cabinet. (B). 20mm. will need assistance to do this), and position it in its permanent location. 12.
BEFORE CALLING FOR SERVICE SERVICE CALLS CAN OFTEN BE AVOIDED! IF YOU FEEL YOUR REFRIGERATOR IS NOT OPERATING CAUSES FIRST PROPERLY, CHECK THESE POSSIBLE : PROBLEM POSSIBLE CAUSES REFRIGERATOR DOES Has NOT OPERATE Has the power cord plug been removed from the electrical wall outlet? TEMPERATURE Temperature control not set on proper position. Appliance is placed close to wall or heat source. Warm weather-frequent door openings. Door left open for a long time.
