ENHANCE D BZ03 GCE-8481B EnglishDeutcFraIopP
CAUTION The laser used in the CD-R/RW drive : Do not to open the attempt To reduce the risk of electric No user-serviceable Refer damage can your eyes. cover. shock, do parts inside. service servicing to qualified Use of controls or performance of not remove cover (or back). personnel. procedures other than those specified herein may result in hazardous radiation exposure.
This product is manufactured to comply with the radio interference requirements 89/336/EEC, 93/68/EEC and 73/23/EEC. of EEC DIRECTIVE CAUTION - INVISIBLE LASER RADIATION WHEN OPEN AVOID EXPOSURE TO BEAM. VARNING-OSYNLIG LASERSTRALNING NAR DENNA DEL AR OPPNAD STRALEN AR FARLIG.
Contents Introduction Features........................................2 ImportantPrecautions.............................3 SystemEnvironment..............................4 LocationandFunctionofControls...................5 Installation InstallingtheDrive...............................6 DeviceDrivers..................................11 Operation HowtoUsetheDiscs............................12 Appendix Troubleshooting.................................13 Specifications..................................
Thank you for this purchasing Features CD-R/RW ? Enhanced-IDE Drive. ? Power (ATAPI) interface. tray loading and ejection of disc. (The disc can also be ejected manually.) ? The recorded CD-RW media can be played in a DVD player Player, maintaining future compatibility multiread CD-ROM Windows 95/98/2000/ME/XP & NT 4.0. ? Supports ? Automatic buffer underrun ? 48X * Writing speed depends on capabilities of For Ultra speed write/rewrite, you should Speed Writable/ReWritable discs.
Important Precautions Follow these Precautions ? when handling the drive or discs. Please take notice that the manufacturer of this offer any or ? precautions warranty against data loss due handling or direct or indirect equipment does not inappropriate installation to damages. Please take notice that the manufacturer will bear direct or indirect damages caused by the use no of this responsibility product or its for responsibility for malfunction.
System Environment Computer This unit can System requirements be operated CPU in the system environment explained here. 350MHz (or faster) 500MHz or faster Pentium Windows 95/98/ME Memory (for high speed, recommended) 64MB : or greater. Windows NT Workstation Ver. 4.0: 64MB greater (128MB or recommended) Windows 2000/XP: 128MB or greater(256MB over recommended) Hard disk 650MB or over free space. for or more (The free space needed the quantity of data.
DirectCDTM v2.5b(s) Introduction Location and Function of Controls Front Panel 6 5 12 1. 3 4 Headphone Jack 2. Volume Control 3. Emergency Eject Hole Stop/Eject Button 5. Disc Tray 6. Drive activity indicator (Read/Write) 4. Rear Panel POWER INTERFAC E DIGITAL AUDIO DG ANALOG AUDIO CSM 1. 3. +12 4 5 Digital Audio Output Connector Analog Audio Output Connector Jumper Connector This determines whether the drive is jumper Changing 4. GND 2 RGL SLA 123 2.
DirectCDTM v2.5b(s) Installation Installing Before Before the Drive the installing drive, please You will need the Installation ? A screw note the following points. following: driver of a suitable size to fit the securing computer, find the screws for the drive unit. ? The manual for the positions so you can mounting for the IDE controller cable. Turn off all peripheral appliances of the computer and the computer itself, and disconnect their power cords from the wall sockets.
DirectCDTM v2.5b(s) Installation Before Jumper Setup installation, set the jumper on the jumper connector the on rear panel. The drive be connected can (up must be set in way. a unique the Master or Slave on an EIDE (ATAPI) four) EIDE devices are connected, each Specific knowledge of hardware and as interface. When several to software is necessary to install the drive.
DirectCDTM v2.5b(s) Installation The CD-R/RW drive connects to the motherboard of the host PC Connection To Install as a an IDE interface cable. You may connect the CD-R/RW Drive Slave or Master device, depending To install the drive Master Drive computer using the as a on your Master, the jumper as a computer. can be left from supplied as factory.
DirectCDTM v2.5b(s) To Install Installation To install the drive as a panel Slave Drive as a Slave, change the jumper setting on the rear to SL.
DirectCDTM v2.5b(s) Installation Connect the 40-pin IDE cable to the back of the CD-R/RW Drive, making sure the coloured (red) stripe on the IDE cable is connected to pin 1 on the CD-R/RW drive. Pin 1 is closest to the Power Connector. Connecting the Interface Connector NOTE : Generally, the IDE connector is POWER INTE RFACE ANALOG DIGITAL AUDIO AUDIO CSM RGL SLA 1 GND +5 keyed and will only fit one way.
Device Drivers When using Windows 95/98/2000/ME/XP Workstation Ver. 4.0, or Window NT special device driver is required. Your system, upon Power On and bootup after installing and connecting the new CDRW drive, will recognize and load native software drivers automatically. no The DOS and Windows 3.1 anytime users can download the DOS Device drivers via internet. For your information, please consult the following http://www.lge.com http://www.lgeservice.com/drivers.
DirectCDTM v2.5b(s) Operation How to Use the Discs When CD-ROM using discs, CD-R discs or only read and write errors, but data causes due to labels to the discs. or any stickers damage may be DO NOT use discs, don't attach on the disc may be lost a high speed! warped discs. The very or drive's optical non-standard discs. NON-standard discs may not unit play or properly. Non-standard discs are type discs.
Troubleshooting Before Before ? Requesting Service ? calling for service, check this list. The drive doesn't have power. ? Is the power ? Is the Power Connector to the drive The ? ? ? supply system doesn't cable from the host computer plugged in? securely attached? start.
Specifications Host Interface E-IDE/ATAPI Disc diameters Supported 12cm/8cm, standard size CD's discs Read Function: CD-ROM, CD-ROM XA, Audio CD, Mixed Mode (Audio and (Single Data Photo CD and Combined), CD-I FMV, Video CD, Multi-Session), CD-Plus/CD-Extra, CD-Text, CD-R, CD-RW Write Function: CD-ROM, CD-ROM XA, Audio CD, Mixed Mode and Data (Audio Combined), CD-I FMV, Video CD, CD-Plus/CD-Extra Mounting direction Read/Write Horizontal/Vertical Write 24X PCAV, 32X PCAV, PCAV, 48X CAV
ⓒ 2002 Copyright Caution! The disc rotates at high speed in the drive unit. Use of worn, damaged, or non-standard CD-ROM discs can only adversely affect the drive and cause the disc to LG Electronics U.S.A. Inc. 1000 Sylvan Ave. Englewood Cliffs NJ 07632 U.S.A. or shatter http://www.lgeus.com or LG Electronics Canada Inc. Superior Blvd, Mississauga Ontario, Canada 12, use a damaged extremely rare steps which can be taken to inserting them into 1. Take Willich, Germany LG Electronics U.
