Owner's Manual

Safety Precautions
6 Single Package Type Air Conditioner
■ Installation
CAUTION
Always check for gas
(refrigerant) pressure after
installation or repair of product.
• Low refrigerant levels may cause
failure of product.
Install the drain hose to
ensure that water is drained
away properly.
• A bad connection may cause
water leakage.
Keep level even when
installing the product.
• To avoid vibration or water
leakage.
Do not install the product
where the noise or hot air
from the outdoor unit could
damage the neighborhoods.
• It may cause a problem for your
neighbors.
Don't use people to lift and
transport the product.
• Avoid personal injury.
Do not install the product
where it will be exposed to
sea wind (salt spray) directly.
• It may cause corrosion on the
product. Corrosion, particularly on
the condenser and evaporator fins,
could cause product malfunction or
inefficient operation.
90°
When the product is not be used for a long
time, disconnect the power supply plug or
turn off the breaker.
• There is risk of product damage or failure, or
unintended operation.
Take care to ensure that nobody could step
on or fall onto the unit.
• This could result in personal injury and product
damage.
Having perfect vacuum process in the factory, our units don't have drier but have filter in the
refrigerant circuit.
In case of recharging gas in the field,
"DRIER" must be installed on the liquid line which is connected from discharge part of
condenser to intake part of evaporator. Because the refrigerant circuit is capable of containing
water with imperfect vacuum.