Owner's Manual

12
ENSURING PROPER AIR CIRCULATION
In order to obtain stable temperature, the air must
flow between the freezer and refrigerator sections.
As shown in the illustration below, the cold air
enters through the bottom part and circulates
upward. This air returns below the freezer floor and
the rest of the air enters the refrigerator section
through the top vent.
MULTI FLOW
The cooling fan operates more powerful and
effective than when in normal operation. This is
especially noticeable when new food is placed in
the refrigerator compartment.
If the lining is damaged, water or other substances
could enter through the cool air vent causing
decreased efficiency.
Do not block any of these vents with packages of
food. This can interrupt the flow of air and cause
temperature and moisture problems.
IMPORTANT: Because air circulates between both
sections, any odors formed in one section will
transfer to the other. You must thoroughly clean
both sections to eliminate odors. To prevent odor
transfer and drying out of food, make sure you wrap
or cover foods tightly (See the Food Storage Guide
section for details).
DOOR ALARM
With this feature you will hear an alarm when the
freezer or refrigerator door is ajar for more than 1
minute. These tones will repeat every 30 seconds.
The alarm is cancelled when the door is properly
shut.
SETTING THE CONTROLS
(Models with water dispenser)
IMPORTANT: Wipe out moisture before using the
display button as operation of the button is based
on touch sensing method and becomes slow or
other buttons may operate if moisture is stuck to the
surface of the button.
• Your refrigerator has a control pad on the
dispenser that lets you regulate the temperature
in the freezer and refrigerator compartments.
• Initially set the REFRIGERATOR CONTROL at
37 °F (3 °C) and the FREEZER CONTROL at 0
°F (–18 °C). Leave it at this setting for 24 hours
(one day) to stabilize. Then adjust adjust the
compartment temperature as desired.
• Refrigerator Temp Control: 33 °F to 46 °F (0 °C
to 8 °C) The lower the number setting, the colder
the refrigerator compartment will become.
• Freezer Temp Control: -6 °F to 8 °F (-21 °C to
-13 °C) When the setting is at a lower number,
the freezer compartment becomes colder. The
refrigerator compartment becomes warmer
because less cold air flows into the refrigerator.
• Display OFF Mode: To activate this mode press
and hold ICE PLUS and FREEZER key over 5
seconds until the lights turn off. If the Display is
touched or any door opens the lights will turn on
and after 20 seconds of inactivity the lights will
turn off automatically.
To exit Display OFF Mode press and hold ICE
PLUS and PLUS and FREEZER key over 5
seconds until the lights tilt. Display Energy Save
Mode does not affect the temperature control
settings of the unit.
NOTE: If you want to change °F to °C or the reverse,
press and hold FREEZER key and REFRIGERATOR
key simultaneously for 5 seconds or more.
NOTE: Touch display once to activate, then touch
again to change the settings or activate a function. If
10 seconds have passed since the display has been
touched, it will be necessary to touch “once” again to
reactivate.
This is to prevent accidental display setting changes.
• Ice Plus: Press the ICE PLUS button and the LED
will turn on. This function will remain activated for
24 hours and increase the cooling speed of the
freezer and the amount of ice produced.
• Filter Reset: It displays in months the number
of months left to exchange the filter from the
moment power is connected to the refrigerator. If
you have changed the filter after 6 months of use,
press and hold the FILTER button 3 seconds or
more and the filter display will be initialized with a
buzzing sound.
USING YOUR REFRIGERATOR