Owner's Manual

13
• Dispenser Lock: Press and hold the LOCK button
for 3 seconds to lock the dispenser When it is
locked, the dispenser will not operate. To unlock,
press and hold the LOCK button for 3 seconds.
NOTE: The average life of the filter is 6 months.
WARNING: If a door is open, the dispenser does not
work.
ADJUSTING CONTROL SETTINGS
Give the refrigerator time to cool down completely before
adding food. It is best to wait 24 hours before adding
food to the refrigerator. The mid-settings indicated in the
previous section should be correct for normal household
refrigerator usage. The controls are set correctly when
milk or juice is cold to your liking and ice cream is firm.
The refrigerator control functions as the thermostat for
the entire appliance. The higher the number setting, the
longer the compressor will run to keep the temperature
colder. The freezer control adjusts the cold air flow from
the freezer to the refrigerator. Setting the freezer control
to a lower temperature keeps more cold air in the freezer
compartment to make it colder.
If you need to adjust the temperature in the refrigerator
or freezer, begin by adjusting the refrigerator first. Wait
24 hours after the refrigerator adjustment to check the
freezer temperature. If it is too warm or too cold, then
adjust the freezer control as well.
Use the settings listed in the table below as a guide.
CONDITION/REASON: RECOMMENDED
ADJUSTMENT:
REFRIGERATOR section
is too warm
•Opening the door often
•Adding a large amount
of food
•Room temperature is
very warm
Adjust the
REFRIGERATOR setting
to the next highest
number and wait 24
hours, then check.
FREEZER section is too
warm/ ice is made too
slowly
•Opening the door often
•Adding a large amount
of food
•Room temperature is
very low (not cycling
often enough)
•Using ice frequently
•Air vents blocked by
objects
Adjust the FREEZER
setting to the next
highest number and wait
24 hours, then check.
Remove any objects
blocking air flow.
REFRIGERATOR section
is too cold
•Controls not set
correctly for your
conditions
Adjust the
REFRIGERATOR setting
to the next lowest
number and wait 24
hours, then check.
FREEZER section is too
cold
•Controls not set
correctly for your
conditions
Adjust the FREEZER
setting to the next lowest
number and wait 24
hours, then check.
WATER DISPENSER
Push the dispenser pad
with a glass until you hear a
click to get cold water.
Tray can be easily removed
by pressing and pulling it.
Tilt up the front of tray
slightly and snap the ribs
into the holes to replace
the tray.
Important: When the refrigerator is first connected
to the water supply, it’s necessary to dispense 2.5
gallons (9.46 liters) of water to remove trapped air
from the system. (Approximately 5 minutes). This is
necessary to avoid possible leaks or problems when
dispensing water.
Push
Dispenser
Switch
Holes
Ribs
USING YOUR REFRIGERATOR