Owner's Manual

20
FILTER
It is recommended that you replace the filter when the
water filter indicator light turns on or your water
dispenser or ice maker decreases noticeably.
After changing the water filter cartridge, reset the water
filter status display and indicator light by pressing and
holding the BUTTON for 3 seconds.
How to change the old cartridge.
1. Turn the shutoff valve off (house valve).
2. Dispense water from the system to empty the tubing
(approximately for 50 seconds).
3. Remove the old cartridge.
Rotate the knob of the cartridge counter clockwise.
When the cartridge is removed, it will click out of
place.
Pull out the cartridge.
NOTE: There will be water in the cartridge. Some
spilling may occur through the hole at rear bottom side
of cover. You may use a cup or something like that to
prevent spilt water drop into food.
4. Replace with a new cartridge.
Take the new cartridge out of its packaging and
remove protective cover from the o-rings.
With cartridge knob in the vertical position, push the
new filter cartridge into the cover until it stops.
If you can´t turn the filter from side to side, it isn’ t
fully inserted. Push it in firmly and twist it into place.
You will hear it click into place.
Using its handle, twist the cartridge clockwise about
1/4 turn. You will hear when it clicks into place.
5. Turn the shutoff valve on (house valve).
After installing water filter:
1. Turn on household water supply.
2. Dispense 2.5 gallons (9.46L) of water to purge the
system, depressing and releasing the dispenser
button (30 seconds ON, 60 seconds OFF). Open
the refrigerator door and shelf area to check for water
leaks.
REFRIGERATOR CARE AND CLEANING