Owner's Manual

7
HOW TO REMOVE AND INSTALL REFRIGERATOR DOOR
1. Removing Refrigerator Doors
Remove the left-side door first.
NOTE: Handle, top hinge and hinge cover appearance may vary from illustrations on this page.
WARNING
• Disconnect electrical supply to the refrigerator before installing. Failure to do so could result in death or serious
injury.
• Do not put hands or feet or metal sticks into the air vents, base grille, or bottom of the refrigerator. You may be
injured or receive an electrical shock.
• Be careful when you work with the hinge, base grille, and stopper. You may be injured.
• Remove food and any bins from doors.
X Left Door
• Loosen the screws and remove the cover on back side (see figure A).
• Disconnect water supply tube by pushing back on the disconnect ring (3).
• Loosen the cover screw (1).
• Disconnect door switch wire (2).
• Pull out the tube (4).
CAUTION: If a tube end is deformed or worn out, cut the damaged portion away.
• Disconnect wire harness (5).
• Loosen screws (6) and lift off the top hinge (7).
• Place the door on a non-scratching surface with the inside up.
CAUTION: When removing top hinge, be careful that the door does not fall forward.
X Right Door
• Loosen the cover screw (1).
• Disconnect door switch wire (2).
• Disconnect wire harness (4).
• Remove the ground screw (8).
• Loosen screws (6) and lift off the top hinge (7).
• Place the door on a non-scratching surface with the inside up.
Figure A
3
(6)
(1)
(7)
(1)
(2)
(6)
(7)
(4)
(2)
(8)
(5)
(4)
REFRIGERATOR INSTALLATION REFRIGERATOR INSTALLATION