Owner's Manual

16
HOW TO USE
HOW TO USE
Before use
Clean the refrigerator.
Clean your refrigerator thoroughly and wipe off all dust that may have
accumulated during shipping.
NOTE
Remove adhesive residue by wiping it off with your thumb or
dishwashing detergent.
CAUTION
Do not scratch the refrigerator with a sharp object or use a
y
detergent that contains alcohol, a flammable liquid or an abrasive
when removing any tape or adhesive from the refrigerator,.
Do not peel off the model or serial number label or the technical
y
information on the rear surface of the refrigerator.
Connect the power supply.
Check if the power supply is connected before use.
Read the “Turning On The Power” section. (Your plug type might be
different from the picture.)
CAUTION
Putting food in the refrigerator before it has cooled could cause the
food to spoil, or a bad odor could remain inside the refrigerator.
Wait for the refrigerator to cool.
Allow your refrigerator to run for at least three to four hours before putting
food in it. Check the flow of cold air in the freezer compartment to ensure
proper cooling.
The refrigerator makes a loud noise after initial operation.
This is normal. The loudness will decrease as the temperature lowers.
Before Plugging in, open the refrigerator doors to ventilate the interior.
The inside of the refrigerator may smell like plastic at first. Remove any
adhesive tape from inside the refrigerator and open the refrigerator doors
for ventilation until any odors have subsided.