ENGLISH ESPAÑOL FRANÇAIS INSTALLATION GUIDE HOOD Read these instructions thoroughly before installing and operating the hood. LSHD3689BD LSHD3680ST HCED3615S LSHD3089BD LSHD3080ST HCED3015S www.lg.com MFL70208702_03 Copyright © 2017 - 2019 LG Electronics Inc. All Rights Reserved.
TABLE OF CONTENTS TABLE OF CONTENTS 3 Before You Begin 14 Installation Instructions 14 4 IMPORTANT SAFETY INSTRUCTIONS 7 Product Specifications 7 8 General Specifications Dimensions 9 PRODUCT OVERVIEW 9 9 Parts Accessories 10 Planning the Installation 10 11 12 13 13 Cabinet Layout Ducting Options Ducting Calculation Sheet Power Supply Verify the Package Contents Mounting the Range Hood 15 Wiring Diagram
Before You Begin Important: •• Installer: In the interest of safety and to minimize problems, read these installation instructions completely and carefully before you begin the installation process. Leave these installation instructions with the customer. •• Customer: Keep these installation instructions for future reference and the local electrical inspector’s use. APPLIANCE DATA PLATE •• The appliance data plate contains the model and serial number information and the electrical requirements.
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT SAFETY INSTRUCTIONS Read and follow all instructions when using the range to prevent the risk of fire, electric shock, personal injury, or damage. This guide does not cover all possible conditions that may occur. Always contact your service agent or manufacturer about problems that you do not understand. Download this owner's manual at: http://www.lg.com This is the safety alert symbol.
IMPORTANT SAFETY INSTRUCTIONS •• TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS, OBSERVE THE FOLLOWING: –– Installation work and electrical wiring must be done by qualified person(s) in accordance with all applicable codes and standards, including fire-rated construction. –– Sufficient air is needed for proper combustion and exhausting of gases through the flue(chimney) of fuel burning equipment to prevent back drafting.
IMPORTANT SAFETY INSTRUCTIONS Warning •• Never allow the filter(s) to become blocked or clogged. Do not allow foreign objects, such as cigarettes or napkins, to be sucked into the hood. •• Clean the filter(s) and all grease-laden surfaces often to prevent grease fires and maintain performance. • • If the cooktop and range hood are near a window, use an appropriate window treatment. Avoid long drapes or other window coverings that could blow over the cooktop and hood, resulting in a fire hazard.
Product Specifications General Specifications All Models Fan Speeds 5 Filters Aluminum mesh filters Total Connect Load 120 VAC, 60 Hz, 4 Amp. Lights 120 VAC, 8 W LED light strip Model Specific Model Number LSHD3689BD, LSHD3680ST, HCED3615S, LSHD3089BD, LSHD3080ST, HCED3015S Filters 2 Weight Specifications Model Number Weight LSHD3689BD, LSHD3680ST, HCED3615S 37 lb. (17 kg) LSHD3089BD, LSHD3080ST, HCED3015S 35 lb.
Product Specifications Dimensions Tolerances: +1/16", -0 (1.6 mm, -0), unless otherwise stated. NOTE The exhaust duct(s) and electrical wiring can be connected from either the top or the back of the hood. 10 5/8″ 10 3/8″ 1 3/16″ 5 5/16″ 18 7/16″ STANDARD min. ducted - 27″ min. recirc. - 31″ max.
PRODUCT OVERVIEW ENGLISH PRODUCT OVERVIEW Parts 3 2 1 4 5 1 Hood 4 Mesh Filter 2 Icon Touch Control Panel 5 Side Panel (Only for LSHD3689BD, LSHD3680ST, HCED3615S) 3 LED Strip Light 9 Accessories Included Accessories Manual Duct cover bracket Duct cover Manual M6 x 1-1/2" (2) M4 x 8 (2) Wire Caps (3) M6 x 1" (3)
Planning the Installation Planning the Installation Minimum Cabinet Width Standard Duct Cover Warning Observe all governing codes and ordinances during planning and installation. Contact your local building department for further information. Use only duct work deemed acceptable by state, municipal and local codes.
Planning the Installation 11 ENGLISH Ducting Options Warning Fire Hazard •• NEVER exhaust air or terminate duct work into spaces between walls, crawl spaces, ceiling, attics or garages. •• All exhaust must be ducted to the outside. •• Use metal ductwork only. •• Fasten all connections with sheet metal screws and tape all joints with certified Silver Tape or Duct Tape.
Planning the Installation Ducting Calculation Sheet Duct pieces Equivalent length x number used = Total Duct pieces Equivalent length x number used = Total 3-1/4" x 10" Rect., straight 1 Ft. x( )= Ft. 6" Round 30 Ft. wall cap with damper x( )= Ft. 6" Round, straight 1 Ft. x( )= Ft. 6" Round, roof cap 30 Ft. x( )= Ft. 7"-10" Round, straight 1 Ft. x( )= Ft. 1 Ft. x( )= Ft. 3-1/4" x 10" Rect.90˚ elbow 15 Ft. x( )= Ft. 6" round to 3-1/4" x 10" rect.
Planning the Installation 13 Electrical Supply Wherever possible, reduce the number of transitions and turns to as few sharp angles as possible. Two staggered 45° angles are better than one 90°. This appliance requires a 120V 60Hz electrical supply, and must be connected to an individual, properly grounded branch circuit, protected by a 15 or 20 ampere circuit breaker or time delay fuse. Wiring must be 2 wire w/ ground. Please also refer to the Electrical Diagram label on product.
Installation Instructions Installation Instructions WARNING •• Do not install the range hood unless the electrical service provided meets the range hood specifications. •• Observe all governing codes and ordinances during installation. Contact your local building department for further information. •• A qualified technician must complete the installation of this built-in appliance. More than one person is required to raise the hood into place.
Wiring Diagram 15 Models Volts HZ MAX Amps LSHD3089BD LSHD3080ST HCED3015S LSHD3689BD LSHD3680ST HCED3615S 120 60 4 ENGLISH Wiring Diagram
Memo Memo
