Installation Guide

5
IMPORTANT SAFETY INSTRUCTIONS
ENGLISH
WARNING
•
TO REDUCE THE RISK OF FIRE, ELECTRIC SHOCK, OR INJURY TO PERSONS,
OBSERVE THE FOLLOWING:
– Installation work and electrical wiring must be done by qualified person(s) in
accordance with all applicable codes and standards, including fire-rated construction.
– Sufficient air is needed for proper combustion and exhausting of gases through the
flue(chimney) of fuel burning equipment to prevent back drafting. Follow the heating
equipment manufacturer’s guidelines and safety standards such as those published
by the National Fire Protection Association (NFPA), and the American Society for
Heating, Refrigeration and Air Conditioning Engineers (ASHRAE), and the local code
authorities.
– When cutting or drilling into wall or ceiling, do not damage electrical wiring and other
hidden utilities.
– Ducted fans must always be vented to the outdoors.
CAUTION
For general ventilating use only. Do not use to exhaust hazardous or explosive materials
and vapors.
GENERAL SAFETY PRECAUTIONS
To reduce the risk of fire, electric shock, serious injury or death when using the appliance,
follow basic safety precautions, including the following:
WARNING
•
Do not install or operate this hood if it has been damaged, dropped, has damaged
electrical wires or is not working properly. If the product is damaged when received,
immediately contact the dealer or builder.
•
This range hood must be installed and grounded by a qualified installer according to
these installation instructions.
•
Install or locate this appliance only in accordance with these installation instructions
and the requirements specified by the manufacturer of the cooktop or range. Improper
installation, adjustment, alteration, service or maintenance can cause serious personal
injury or property damage.
•
The customer should not install, repair or replace any part of the range hood unless
specifically recommended in the literature accompanying it. A qualified service
technician should perform all other service.
•
Keep all packaging materials away from children. Plastic bags can cause suffocation.
•
Do not use an extension cord or adapter plug with this appliance.
•
The installer must show the customer the location of the fuse box or circuit breaker
panel box so that the customer knows where and how to turn the power off.
•
Before installing or servicing the range hood, switch power off at the fuse box circuit
breaker and lock the electrical panel door to prevent power from being switched on
accidentally. When the electrical panel cannot be locked, securely fasten a prominent
warning device, such as a tag, to the electrical panel.
•
Read the owner's manual completely before using the appliance. Clean the appliance
only as instructed in the owner's manual. Use only the cleaners specified.
•
Do not tamper with the controls.