Owner's Manual

16 Installation
Installation
 3
Setting an ID for the wireless
subwoofer
When the unit is manufactured, the ID is
already set. If interference occurs or you use
a new wireless subwoofer, an ID should be set
again.
1. Press HOME ( ).
2. Use
I
/
i
to select the [Setup] and
press ENTER ( ). The [Setup] menu appears.
3. Use
U
/
u
to select [AUDIO] option then
press
i
to move to the second level.
4. Use
U
/
u
to select the [Connecting speakers]
option then press ENTER ( ) to move to
the third level.
The [Wireless Speaker Connection Guide]
appears.
5. Press PAIRING button on the subwoofer.
- If you see the blue LED indicator light,
pairing was successful.
6. Use
U
/
u
to select the [5.1 Speaker Setup]
and press ENTER ( ) for wireless speaker
connection test.
NOTE
• If there is a strong electromagnetic wave
product nearby, interference may occur. Put the
unit (Wireless subwoofer and main unit) away
from there.
• If you operate main unit then wireless subwoofer
(rear speakers) sound within a few seconds in
standby mode.
• Set the distance between this unit and
subwoofer Receiver within 10 m (32 ft.).
• Optimum performance can be implemented
only when the unit and the Wireless subwoofer
within distance of 2 m (6 ft.) to 10 m (32 ft.) is
used since communication failure may occur if
longer distance is used.
• It takes a few seconds (and may take longer)
for the Wireless Transmitter and subwoofer to
communicate with each other.
About Ferrite Core (OPTIONAL)
– for EMI only
You must ax the cores (supplied with the model
you purchased) in order to reduce or eliminate
electrical interference.
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to open.
2. Wind the cable once on the ferrite core. Attach
the ferrite core near the unit (Refer to the g.3
and comment.).
3. Close the ferrite core until it clicks.
2 Connecting
About Ferrite Core (for EMI only)
Be sure to attach the ferrite core to the speaker
cable. This ferrite core can reduce noises.
How to attach the ferrite core
1. Press the stopper [a] of the ferrite core to open.
2. Wind the power code of the unit once on
the ferrite
core.
3. Close the ferrite core until it clicks.
Refer to the g.3 and comment.
(g.3)
The length
here is as
short as
possible.
HLT55W-F2_DRUSLLE_ENG_9812.indd 16 2014-01-20 �� 2:24:12